Zenoah BCZ4200CL, BCZ4000DW Adjusting Throttle Cable, Adjusting Idling Speed, Metal Blade Usage

8. Operation

ADJUSTING THROTTLE CABLE

•The normal play is 1 or 2 mm when measured at the carburetor side end. Readjust with the cable adjuster as required.

BCZ4000DL / BCZ4000DW / BCZ4200CL

METAL BLADE USAGE

(1) Idle adjusting screw (cross screw)

1.When the engine tends to stop frequently at idling mode, turn the adjusting screw clockwise.

2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter-clockwise.

NOTE

• Warm up the engine before adjusting the idling speed.

CUTTER APPLICATION CHART

•Replace by a suitable recommended cutting attach- ment according to the object to be cut.

•When replacing blade always be sure to use products which have been certified by KOMATSU ZENOAH.

WARNING

•When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper tools and equipment to prevent injury.

WARNING

•The rotating parts fastened incorrectly may cause serious accident to the operator.

•Make sure that the blade is not bent, warped, cracked, broken or damaged.

•If you find any error to the blade, discard it and change new one which is certified by KOMATSU ZENOAH.

•By using the shoulder strap, hang the unit on your right side. Adjust the strap length so that the cutting head may become parallel to the ground.

WARNING

•Make sure to use shoulder strap and cutting at- tachment guard. If not, it is vary dangerous when you slip or lose your balance.

BCZ4200CL848-JL0-6913

BCZ4000DL/DW 848-JG0-6911

BCZ4200CL848-JL0-92A2

BCZ4000DL/DW 6298E3390

•BCZ4000DL, BCZ4000DW, BCZ4200CL : Be sure to use genuine parts made of Zenoah for blades. In par- ticular, never use special blades such as shredder blades. If you use a special blade, the unit may fail.

•BCZ4000DL, BCZ4000DW : Do not use the Zenoah blade 848-JLO-92A2 or the blade whose thickness is more than 2mm.