Poulan PRRT875X manual Troubleshooting Points

Page 19

TROUBLESHOOTING POINTS

PROBLEM

 

CAUSE

 

CORRECTION

Will not start

1.

Out of fuel.

1.

Fill fuel tank.

 

2.

Engine not “CHOKED” properly.

2.

See “TO START ENGINE” in Operation section.

 

3.

Engine flooded.

3.

Wait several minutes before attempting to start.

 

4.

Dirty air cleaner.

4.

Clean or replace air cleaner cartridge.

 

5.

Water in fuel.

5.

Empty fuel tank and carburetor, and refill tank with fresh

 

 

 

 

gasoline.

 

6.

Clogged fuel tank.

6.

Remove fuel tank and clean.

 

7.

Loose spark plug wire.

7.

Make sure spark plug wire is seated properly on plug.

 

8.

Bad spark plug or improper gap.

8.

Replace spark plug or adjust gap.

 

9.

Carburetor out of adjustment.

9.

Make necessary adjustments.

 

10.

Oil soaked air filter.

10.

Replace air filter.

 

 

 

 

 

Hard to start

1.

Throttle control not set properly.

1.

Place throttle control in “FAST” position.

 

2.

Dirty air cleaner.

2.

Clean or replace air cleaner cartridge.

 

3.

Bad spark plug or improper gap.

3.

Replace spark plug or adjust gap.

 

4.

Stale or dirty fuel.

4.

Empty fuel tank and refill with fresh gasoline.

 

5.

Loose spark plug wire.

5.

Make sure spark plug wire is seated properly on plug.

 

6.

Carburetor out of adjustment.

6.

Make necessary adjustments.

 

 

 

 

 

Loss of power

1.

Engine is overloaded.

1.

Set depth stake for shallower tilling.

 

2.

Dirty air cleaner.

2.

Clean or replace air cleaner cartridge.

 

3.

Low oil level/dirty oil.

3.

Check oil level/change oil.

 

4.

Faulty spark plug.

4.

Clean and regap or change spark plug.

 

5.

Oil in fuel.

5.

Empty and clean fuel tank and refill, and clean carburetor.

 

6.

Stale or dirty fuel.

6.

Empty fuel tank and refill with fresh gasoline.

 

7.

Water in fuel.

7.

Empty fuel tank and carburetor, and refill tank with fresh

 

 

 

 

gasoline.

 

8.

Clogged fuel tank.

8.

Remove fuel tank and clean.

 

9.

Spark plug wire loose.

9.

Connect and tighten spark plug wire.

 

10.

Dirty engine air screen.

10.

Clean engine air screen.

 

11.

Dirty/clogged muffler.

11.

Clean/replace muffler.

 

12.

Carburetor out of adjustment.

12.

Make necessary adjustments.

 

13.

Poor compression.

13.

Contact an authorized service center/department.

 

 

 

 

 

Engine overheats

1.

Low oil level/dirty oil.

1.

Check oil level/change oil.

 

2.

Dirty engine air screen.

2.

Clean engine air screen.

 

3.

Dirty engine.

3.

Clean cylinder fins, air screen, and muffler area.

 

4.

Partially plugged muffler.

4.

Remove and clean muffler.

 

5.

Improper carburetor adjustment.

5.

Adjust carburetor to richer position.

 

 

 

 

 

Excessive bounce/

1.

Ground too dry and hard.

1.

Moisten ground or wait for more favorable soil

difficult handling

 

 

 

conditions.

 

 

 

 

 

Soil balls up or clumps

1.

Ground too wet.

1.

Wait for more favorable soil conditions.

 

 

 

 

 

Engine runs but tiller

1.

Drive control bar is not engaged.

1.

Engage drive control.

won’t move

2.

V-belt not correctly adjusted.

2.

Inspect/adjust V-belt.

 

3.

V-belt is off pulley(s).

3.

Inspect V-belt.

 

 

 

 

 

Engine runs but labors

1.

Tilling too deep.

1.

Set depth stake for shallower tilling.

when tilling

2.

Throttle control not properly adjusted.

2.

Check throttle control setting.

 

3.

Carburetor out of adjustment.

3.

Make necessary adjustments.

 

 

 

 

 

Tines will not rotate

1.

Shear pin(s) broken.

1.

Replace shear pin(s).

 

 

 

 

 

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents PRRT875X Preparation Safety RulesMaintenance and Storage TrainingTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Contents of Hardware PackUnpacking Carton See Fig Install Handle See Figs , 4,Check Tire Pressure Attach Clutch Cable See FigConnect Shift ROD See Fig Remove Tiller from CrateOperation Meets Ansi Safety RequirementsKnow Your Tiller HOW to USE Your Tiller Before Starting Engine To TransportADD Gasoline Tilling Hints Tine Shear PinsCultivating General Recommendations MaintenanceMaintenance Schedule Lubrication ChartEngine AIR Cleaner See FigTo Change Engine OIL See Figs Spark Plug CleaningCooling System See Fig MufflerTiller Service and AdjustmentsTire Care To Replace Ground Drive Belt See Figs Ground Drive Belt Adjustment See FigTine Replacement See Figs , 25, To Adjust Carburetor To Adjust Throttle Control Cable See FigEngine OIL StorageOther Fuel SystemTroubleshooting Points Service Notes HOP Limited WarrantyParts and Service Changere DE Pièces LES ET L’ENTRETIEN Limitée Garantie Dépannage DE Guide Motobineuse EntreposageSupplementaire Information Moteur27 .FIG Réglages ET RévisionMoteur Carburateur LE Régler Pour26 .FIG 26 et 2525 .FIG 24 .FIG Terre À D’ENTRAÎNEMENT Fig la Voir Terre À D’ENTRAÎNEMENT Courroie LA Régler23 et 22 .fig les Voir Courroie LA Remplacer PourFig la Voir Fig la Voir Roue LA Enlever PourFig la Voir Roiecour DE Protecteur LE Enlever PourSilencieux EntretienNettoyage ’ALLUMAGE BougieLubrification Fig la Voir AIR À FiltreLubrification Générales RecommandationsLubrification DE Tableau ’ENTRETIEN Calendrier15 .FIG UtilisationBinage Dents DES Cisaillement DE Boulons13 .FIG Labourage DE ConseilsMoteur LE Démarrer Pour 14 .FIGTransporter Pour Moteur LE Démarrer DE AvantExtérieurs Latéraux Déflecteurs ’ESSENCE Réservoir LE RemplirLA Avec -FRAISES DES Utilisation BineuseMoto Votre Utiliser Comment MENT/LESLESEU ROUES-AVANT MarcheMotobineuse Votre Connaissez Ansi Sécurité DE Exigences AUX ConformeFig la Voir Setesvi MontageEt 4, 3, .fig les Voir Poignee LA InstallerFig la Voir Carton LE Deballer Fig la Voir D’OPERATEUR Position Pièces DES SAC DU ContenuMontage LE Pour Exiges Outils LES Client DU Responsabilités SommaireProduit DE Spécifications En lUtilisation pour Conseils Sécurité DE RèglesEntreposage ET Entretien Motobineuses des Sécurité touteCom.pro-poulan.www web site notre Visitez

PRRT875X specifications

The Poulan PRRT875X is a robust and versatile string trimmer designed for both residential and professional landscaping tasks. Known for its lightweight design and powerful performance, this tool caters to individuals looking to maintain their lawns with precision and ease.

One of the standout features of the PRRT875X is its impressive 25cc, 2-cycle gas engine. This enables the trimmer to deliver a strong performance, allowing users to tackle thick grass, weeds, and overgrown areas without hassle. The engine is designed for easy starting, which reduces the frustration often associated with traditional gas-powered trimmers.

The PRRT875X is equipped with a 18-inch cutting swath, providing ample coverage with each pass. This wide cutting width not only saves time but also enhances efficiency, making it easier to trim larger areas quickly. The dual-line design enables a cleaner cut, distributing power evenly across both lines, resulting in improved performance.

Comfort and usability are key considerations in the design of the Poulan PRRT875X. It features an adjustable handle that allows users to customize the grip for better control and comfort during extended use. The curved shaft design also contributes to ease of operation, reducing strain on the user's back and arms while trimming hard-to-reach areas.

The trimmer also employs a 'Tap-N-Go' line advance system. This technology enables users to easily feed more line by simply tapping the head on the ground, minimizing downtime and enhancing overall productivity. Moreover, the cutting head is designed for quick line replacement, which is a significant advantage for users who require frequent blade changes.

Durability is paramount in the design of the PRRT875X. It features a rugged exterior designed to withstand the rigors of outdoor use. Additionally, its lightweight build, weighing approximately 10 lbs, allows for easy maneuverability and transport.

In terms of environmental considerations, the Poulan PRRT875X meets various emissions standards, making it a greener option in the gas-powered trimmer market.

Overall, the Poulan PRRT875X string trimmer combines power, efficiency, and user-friendly features, making it an excellent choice for anyone looking to maintain their landscape effectively. With its robust engine, wide cutting swath, and focus on comfort, it stands out as a reliable tool for homeowners and professionals alike.
Top Page Image Contents