Poulan 423813 manual Safety Rules, Training, Preparation, Operation, Maintenance and Storage

Page 2

SAFETY RULES

Safe Operation Practices for Walk-Behind Powered Rotary Tillers

TRAINING

Read the Manual carefully. Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly.

Never allow children to operate the equipment. Never allow adults to operate the equipment without proper instruction.

Keep the area of operation clear of all persons, par- ticularly small children, and pets.

Never operate the tiller without proper guards, plates, or other safety protective devices in place.

Keep children and pets away.

Do not overload the machine capacity by attempting to till too deep at too fast a rate.

Never operate the machine at high speeds on slippery surfaces. Look behind and use care when backing.

Never allow bystanders near the unit.

Use only attachments and accessories approved by the manufacturer of the tiller.

PREPARATION

Thoroughly inspect the area where the equipment is to be used and remove all foreign objects.

Disengage all clutches and shift into neutral before starting the engine (motor).

Never operate the tiller without good visibility or light.

Be careful when tilling in hard ground. The tines may catch in the ground and propel the tiller forward. If this occurs, let go of the handlebars and do not restrain the machine.

Do not operate the equipment without wearing ade- quate outer garments. Wear footwear that will improve footing on slippery surfaces.

Handle fuel with care; it is highly flammable.

Use an approved fuel container.

Never add fuel to a running engine or hot engine.

Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.

Replace gasoline cap securely and clean up spilled fuel before restarting.

Use extension cords and receptacles as specified by the manufacturer for all units with electric drive motors or electric starting motors.

Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by manufacturer).

OPERATION

Do not put hands or feet near or under rotating parts.

Exercise extreme caution when operating on or cross- ing gravel drives, walks, or roads. Stay alert for hidden hazards or traffic. Do not carry passengers.

After striking a foreign object, stop the engine (motor), remove the wire from the spark plug, thoroughly inspect the tiller for any damage, and repair the damage before restarting and operating the tiller.

Exercise caution to avoid slipping or falling.

If the unit should start to vibrate abnormally, stop the engine (motor) and check immediately for the cause. Vibration is generally a warning of trouble.

Stop the engine (motor) when leaving the operating position.

Take all possible precautions when leaving the machine unattended. Disengage the tines, shift into neutral, and stop the engine.

Before cleaning, repairing, or inspecting, shut off the engine and make certain all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the plug to prevent accidental starting. Disconnect the cord on electric motors.

Do not run the engine indoors; exhaust fumes are dangerous.

2

MAINTENANCE AND STORAGE

Keep machine, attachments, and accessories in safe working condition.

Check shear pins, engine mounting bolts, and other bolts at frequent intervals for proper tightness to be sure the equipment is in safe working condition.

Never store the machine with fuel in the fuel tank inside a building where ignition sources are present, such as hot water and space heaters, clothes dryers, and the like. Allow the engine to cool before storing in any enclosure.

Always refer to the operator’s guide instructions for important details if the tiller is to be stored for an ex- tended period.

- IMPORTANT -

CAUTIONS, IMPORTANTS, AND NOTES ARE A MEANS OF ATTRACTING ATTENTION TO IMPORTANT OR CRITICAL INFORMATION IN THIS MANUAL.

IMPORTANT: USED TO ALERT YOU THAT THERE IS A POSSIBILITY OF DAMAGING THIS EQUIPMENT.

NOTE: Gives essential information that will aid you to better understand, incorporate, or execute a particular set of instructions.

Look for this symbol to point out im- portant safety precautions. It means CAUTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.

CAUTION: Always disconnect spark plug wire and place wire where it can- not contact spark plug in order to pre- vent accidental starting when setting up, transporting, adjusting or making repairs.

WARNING

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproduc- tive harm.

Image 2
Contents PRRT850 Training Safety RulesMaintenance and Storage PreparationTable of Contents Contents of Hardware Pack AssemblyTools Required for Assembly OPERATOR’S Position See FigInstall Handle See Figs , 4, Unpacking Carton See FigRemove Tiller from Crate Attach Clutch Cable See FigConnect Shift ROD See Fig Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation Forward Wheels ONLY/TINES Stopped HOW to USE Your TillerTine Operation with Wheel Drive Reverse Wheels ONLY/TINES StoppedTo Transport TurningOuter Side Shields See Fig Before Starting EngineADD Gasoline To Start EngineCultivating Tine Shear PinsTilling Hints General Recommendations MaintenanceLubrication Chart Before Each USETo Change Engine OIL See Figs AIR Cleaner See FigEngine Muffler CleaningCooling System See Fig Spark PlugTire Care Service and AdjustmentsTiller Ground Drive Belt Adjustment See Fig To Replace Ground Drive Belt See FigsTine Replacement See Figs , 25, Fuel System StorageOther Engine OILTroubleshooting Points Service Notes L5T 1K6 Customer Service DeptStevens Creek Road Ordan Drive Augusta, GA 30907 USA Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Articles des fabricant du Dept Service Customer Canada AuInitiale d’achat date la de compter à jours ’ENTRETIEN Remarques Dépannage DE Guide LabourageMoteur DE Huile EntreposageCylindres Dalimentation Système26 .Fig Réglages ET Révision26 et 25 25 .Fig 24 .Fig’ENTRAÎCOURROIELAREMPLACERPOUR Fig la Voir Terre À 23 et 22 .Fig les Voir Terre À Nement’ENTRAÎNEMENT Courroie LA Régler 23 .FigFig la Voir Fig la Voir RoieFig la Voir Roue LA Enlever Pour Guidon DU Hauteur LA Régler PourNettoyage Entretien’ALLUMAGE Bougie SilencieuxMoteur LubrificationUtilisation Chaque Avant Lubrification DE TableauLubrification LUBRIFICATION DE TableauLabourage DE Conseils UtilisationBinage Dents DES Cisaillement DE Boulons13 .FIG Fig la Voir Moteur DU Démarrage’ESSENCE Réservoir LE Remplir Moteur DU Démarrage LE Avant Transporter PourExtérieurs Latéraux Déflecteurs Fig la Voir LabourageRoue DE Deman Fig la Voir Profondeur DE JaugeMENT/LESLESEU ROUES-AVANT Marche COM LA Avec -FRAISES DES UtilisationAnsi Sécurité DE Exigences AUX Conforme Motobineuse Votre ConnaissezPneu DE Pression LA Verifier MontagePoignee DE Hauteur Carton DU Motobineuse LA EnleverFig la Voir Carton LE Deballer Poignee LA InstallerEt 4, 3, .Fig les Voir Coupez poignée, la de l’ensemble teniez vous que PendantMontage LE Pour Exiges Outils LES Pièces DES SAC DU ContenuFig la Voir D’OPERATEUR Position De Clé 1 Pince 1 pneu à Manomètre 1 usage tout à CouteauElle .motobineuse d’une achat votre pour Félicitations SommaireClient DU Responsabilités Dallumage BougieMotobineuses des Sécurité toute Sécurité DE RèglesEntreposage ET Entretien En lUtilisation pour ConseilsPRRT850