|
| Troubleshooting and Repair |
|
| |
|
|
|
PROBLEM |
| REMEDY/ACTION |
Belts squeal in neutral and/or reverse | 1. Adjust forward belt guide: | |
| - turn engine off and allow muffler to cool | |
| - disconnect spark plug wire and secure from spark plug | |
| - remove belt guard | |
| - pull down on drive safety control levers | |
| - manually bend forward belt guide so there is 1/16 | |
| inch or less clearance between belt guide and belt | |
| - replace belt guard and spark plug wire | |
|
|
|
Belts squeal in forward operation | 1. Adjust tabs on the reverse belt guide | |
| - turn engine off and allow muffler to cool | |
| - disconnect spark plug wire and secure from spark plug | |
| - release drive safety control levers to neutral | |
| - remove belt guard | |
| - adjust tabs of reverse belt guide: | |
| while drive safety control levers are released, bend | |
| metal tabs on reverse belt guide to 1/64 inch or less | |
| clearance from reverse belt | |
| - replace belt guard and spark plug wire | |
|
|
|
Excessive heat build up in transmission/tine area | 1. Remove vegetation by following instructions in Clean | |
during tilling | Tine Axle Shaft on page 19 of Maintenance & Storage | |
| section. FOLLOW ALL SAFETY INSTRUCTIONS | |
| 2. Check transmission fluid and fill if needed by following | |
| instructions on page 19 | |
|
|
|
Page 23