MTD 460 Series, 450 Series warranty Maintenance & Storage, Your Responsibility

Page 5

After striking a foreign object, stop the engine, disconnect the spark plug wire and ground against the engine Thoroughly inspect the machine for any damage. Repair the damage before starting and operating.

Disengage all clutch levers (if fitted) and stop engine before you leave the operating position (behind the handles). Wait until the tines come to a complete stop before unclogging the tines, making any adjust- ments, or inspections.

Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

Muffler and engine become hot and can cause a burn. Do not touch.

Use caution when tilling near fences, buildings and underground utilities. Rotating tines can cause property damage or personal injury.

Do not overload machine capacity by attempting to till soil too deep at too fast of a rate.

If the machine should start making an unusual noise or vibration, stop the engine, disconnect the spark plug wire and ground it against the engine. Inspect thoroughly for damage. Repair any damage before starting and operating.

Keep all shields, guards, and safety devices in place and operating properly.

Never pick up or carry machine while the engine is running.

Use only attachments and accessories approved by the manufacturer. Failure to do so can result in personal injury.

If situations occur which are not covered in this manual, use care and good judgment. Contact your dealer or call the customer service number found on page two.

Maintenance & Storage

Never tamper with safety devices. Check their proper operation regularly.

Check bolts and screws for proper tightness at frequent intervals to keep the machine in safe working condition. Also, visually inspect machine for any damage.

Before cleaning, repairing, or inspecting, stop the engine and make certain the tines and all moving parts have stopped. Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.

Do not change the engine governor settings or over-speed the engine. The governor controls the maximum safe operating speed of the engine.

Maintain or replace safety and instruction labels, as necessary.

Follow this manual for safe loading, unloading, transporting, and storage of this machine.

Never store the machine or fuel container inside where there is an open flame, spark or pilot light such as a water heater, furnace, clothes dryer, etc.

Always refer to the operator’s manual for proper instructions on off-season storage.

If the fuel tank has to be drained, do this outdoors.

Observe proper disposal laws and regulations for gas, oil, etc. to protect the environment.

Your Responsibility

Restrict the use of this power machine to persons who read, understand, and follow the warnings and instructions in this manual and on the machine.

The safety labels on the tiller are shown in the “Safety Labels” section. To ensure safe operation of the tiller, follow the instructions on all labels closely.

2

Safe

Operation

Practices

WARNING

This symbol points out important safety in- structions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to oper- ate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol, HEED ITS WARNING!

Image 5
Contents MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio OPERATOR’S ManualTable of Contents Your Responsibility Restrict the use Safety LabelsTraining Safe Operation PracticesPreparation OperationYour Responsibility Maintenance & StorageAssembling Your Tiller Tire Pressure Final Clutch AdjustmentAttaching Control Rod Gear Selection Handle Know Your TillerNeutral ReverseClutch Control Handle Adjustment LockThrottle Control Primer Button If EquippedBefore Starting Setting The DepthMaking Adjustments Handle Adjustment Making AdjustmentsBelt Tension Adjustment Engine AdjustmentBelt Replacement Cleaning Tine AreaMaintaining Your Tiller EngineOff-Season Storage Off-Season StorageBracket Engine Pulley2953 800 800-7310 or visit To order replacement Parts, contactPage Part Description 18 Wheel shaft shown For reference only Ref. Part No Problem Cause Remedy Trouble ShootingFor parts and/or Accessories Please call For parts and/or Accessories Please call For parts and/or Accessories Please call MANUFACTURER’S Limited Warranty for