King Kutter TG-48-XB manual Attaching to Tractor, Step

Page 16

ATTACHING TO TRACTOR

WARNING

Never stand between tractor and rotary tiller while backing up tractor to the hitch.

STEP 1 Attach to tractor's category 1 three point hitch as described in the Tractor's Operator’s Manual.

STEP 2

Determine if the PTO shaft needs to be shortened.

NOTE:

Due to the many variations in the tractor hitch points and distances between equipment gearbox input shaft and tractor PTO out put shafts, some combina- tions may require PTO shafts to be shortened as described by the following steps.

STEP 3

Raise and lower rotary tiller in order to locate the shortest distance between equipment gearbox input shaft and tractor PTO output shaft. With the rotary tiller in the shortest distance position shut down the tractor and SECURELY BLOCK ROTARY TILLER IN POSITION.

WARNING: IF THE TILLER IS RAISED UP SO THAT THE PTO SHAFT IS AT AN ANGLE SHARPER THAN 35 DEGREES PTO MUST BE STOPPED!

16

Image 16
Contents Rotary Tiller Page To the Purchaser Page Contents Safety Equipment Safety Guidelines XB-ROTARY Tiller Assembly Instructions Before Putting Rotary Tiller Into ServiceFigure a Figure D Safety Training Starting and Stopping Safety PrepartionOperational Safety Operational Safety Transport Safety Attaching to Tractor StepAttaching to Tractor Sizing PTO Shaft Step Operating Instructions Step Maintenance Maintenance Safety Storage SafetyTop View Page Page Page Page 22 PTO XB Tiller Exploded View TG-48-XB Tiller Parts List TG-48-XB Side Gearbox Parts TG-48-XB Side Gearbox Parts List TG-48-XB Series TOP Gearbox Parts TG-48-XB Series TOP Gearbox Parts List TG-48-XB HUB Parts Part Name Part Number Limited Warranty