King Kutter TG-48-XB manual Attaching to Tractor

Page 17

ATTACHING TO TRACTOR continued....

STEP 4

Pull apart PTO shaft and attach outer section to tractor PTO output shaft. NOTE: Be sure to pull on PTO shaft section to ensure yoke has locked into place.

STEP 5

Place and hold inner PTO shaft section next to outer section and check if PTO shaft is too long. Each section should end approximately 3 inches short of reaching u-joint shield on the opposite section. If the shaft is too long measure 3 inches back from each u-joint shield and mark the other shaft section. Be sure to do this for both PTO shaft halves. NOTE: Do not cut PTO shaft sections at this time.

STEP 6

Raise rotary tiller and remove blocking. Raise and lower rotary tiller in order to locate the longest distance between equipment input shaft and the tractor PTO output shaft. With the rotary tiller in the longest distance position shut down the tractor and SECURELY BLOCK THE ROTARY TILLER IN POSITION.

STEP 7

As in step 5 hold PTO shaft sections together and check for a minimum of 6 inches of overlap. If PTO shaft has been marked for cutting the overlap is the distance measured between the two marks. If the PTO shaft has less than a 6 inch overlap, DO NOT USE. Contact your authorized King Kutter Dealer.

NOTE

If the PTO shaft length is too long go to SIZING PTO SHAFT (pg. 18)

STEP 8

Apply any multi-purpose grease to the outside of the male (inner) PTO shaft section. Assemble PTO shaft and install on rotary tiller and tractor.

STEP 9

Pull on tractor side of PTO shaft yoke to be sure it has locked in place. Make certain PTO shaft shielding is in place and good working condition.

STEP 10

The PTO shaft shield is a non-rotating design and must be secured prior to equipment use. Using the chain on each yoke shield attach to a fixed object on the tractor and equipment ends that will not allow the PTO shaft shield to rotate during operation.

17

Image 17
Contents Rotary Tiller Page To the Purchaser Page Contents Safety Equipment Safety Guidelines Before Putting Rotary Tiller Into Service XB-ROTARY Tiller Assembly InstructionsFigure a Figure D Safety Training Prepartion Starting and Stopping SafetyOperational Safety Operational Safety Transport Safety Step Attaching to TractorAttaching to Tractor Sizing PTO Shaft Step Operating Instructions Step Maintenance Storage Safety Maintenance SafetyTop View Page Page Page Page 22 PTO XB Tiller Exploded View TG-48-XB Tiller Parts List TG-48-XB Side Gearbox Parts TG-48-XB Side Gearbox Parts List TG-48-XB Series TOP Gearbox Parts TG-48-XB Series TOP Gearbox Parts List TG-48-XB HUB Parts Part Name Part Number Limited Warranty