Replace and tighten the (2) plugs and clean away any excess oil.
Remove Breather Plug (Located at top of side gearbox, See (FIG. D point 1 on next page), there is also a plug at the bottom (Located in the side of the side gearbox) (FIG. D point 2 on next page) if oil comes out of lower plug, replace plug immediately and go to STEP 6 , if oil doesn’t come out of lower plug fill with gear oil (type
Replace and tighten the plugs. Clean away any excess oil.
Grease the grease fitting on the "outboard hub, (Fig. E on next page) the two (2) grease fittings on the PTO universal joints, the two (2) grease fit- tings on the PTO safety shield and the inner surface portion of the PTO shaft. See Figures F and G.
CAUTION:
DO NOT over fill gearbox. This could cause damage to oil seals and can cause per- manent damage to the gearbox. This issue will not be covered under warranty.
Figure A | Figure B |
Figure C | 9 |