iNSERT CABLE CLiP
oInsert plastic cable clip into hole on the back of handle column° Push cables
into clip,
REMOVE TILLER FROM CRATE
o Adjust handle assemby to lowest posi- tion. Be sure lock lever is tightened
securely,
° Make sure shift lever indicator is in "N"
Handle Column |
| (neutral) | position. | ||
|
| o Tilt tiller forward by lifting handle. | |||
|
| Separate cardboard cover from leveling | |||
| Cables | shield, |
| ||
,,\ | o Rotate tiller handle to the right and pull | ||||
| |||||
| tiller | out | of carton. | ||
| CHECK | TiRE PRESSURE | |||
Cable Clip
CONNECT SHIFT ROD
oInsert end of shift rod farthest from bend into hole of shift lever indicator,
o Insert hairpin clip through hole of shift rod io secure,
o Insert other end of shift rod into hole in shift lever°
o Insert second hairpin clip through hole of shift rod,
The tires on your unit were overinflated at the factory for shipping purposes, Correct
and equal tire pressure is important for best tilling performance,
=Reduce tire pressure to 20 PSI.
HANDLE HEIGHT
=Handle height may be adjusted to better
suit operator. (See "TO ADJUST HAN- DLE HEIGHT' in the Service and
Adjustments section of this manual).
Attach | this | end to shift lever | _ |
_.- Attach | this | End To shift | \ |
Lever | Indicator | Shift Rod | |
Shift Rod |
| Hairpin Clip | Shift Lever |
|
|
| Indicator |
Shift Lever
rHairpin Clip
Shift Rod