Electrolux FN620K owner manual Service and Adjustments, Tiller, To Adjust Handle Height See Fig

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 15)

Factory assembly has provided lowest handle height. Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.

•If a higher handle height is desired, loosen the four nuts securing handle panel to engine brackets.

•Slide handle panel to desired location.

•Tighten the four nuts securely.

ENGINE

BRACKETS

HANDLE

PANEL

NUTS (ALSO 2

ON LEFT SIDE

OF TILLER)

FIG. 15

TINE ARRANGEMENT

Your outer tines can be assembled in several different ways to suit your tilling or cultivating needs.

CAUTION: Tines are sharp. Wear gloves or other protection when han- dling tines.

MID-WIDTH TILLING - 15" PATH (See Fig. 17)

•Assemble holes “A” in tine hubs to holes “C” in tine shaft.

A CC A

FIG. 17

NARROW TILLING - 10-1/4" PATH (See Fig. 18)

•Remove outer tines.

INNER TINES ONLY

FIG. 18

NARROW CULTIVATING - 12-1/2" PATH (See Fig. 19)

•Remove inner tines.

•Assemble holes “A” in tine hubs to holes “C” in tine shaft.

A C C A

NORMAL TILLING - 17" PATH (See Fig. 16)

•Assemble holes “A” in tine hubs to holes “B” in tine shaft.

CLEVIS	OUTER TINE
PIN
A	A
B
	B
HAIRPIN CLIP	INNER TINE

FIG. 16

FIG. 19

EDGING - 9-5/8" PATH (See Fig. 20)

•Remove inner tines.

•Assemble holes “A” in tine hubs to holes “D” in tine shaft.

A DD A

FIG. 20

13