Husqvarna DRT900E owner manual Tine Replacement See Figs , 28

Page 17

SERVICE AND ADJUSTMENTS

TINE REPLACEMENT (See Figs. 27, 28 and 29)

CAUTION: Tines are sharp. Wear gloves or other protection when han- dling tines.

A badly worn tine causes your tiller to work harder and dig more shallow. Most important, worn tines cannot chop and shred organic matter as effectively nor bury it as deeply as good tines. A tine this worn needs to be replaced.

NEW TINE

WORN TINE

 

 

 

 

tines_21(rear tines)

Fig. 27

•To maintain the superb tilling performance of this ma- chine the tines should be checked for sharpness, wear, and bending, particularly the tines which are next to the transmission. If the gap between the tines exceeds 3-1/2 inches they should be replaced or straightened as necessary.

•For tines that are slightly worn, the bolted tine and hub assemblies can be switched between sides to continue tilling in the same tilling mode if tilling in a different mode is desired then the bolted tine and hub assemblies should be switched back to their original side so that the tine edge with the least wear will be used.

tine_19

TINE

TINE

3-1/2" MAX

Fig. 28

 

HAIRPIN CLIP

 

SHARP EDGES

SHARP EDGES

 

 

HAIRPIN

SHARP EDGES

 

CLIP

SHEAR PIN

tine_20

Fig. 29

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents DRT900E Maintenance and Storage Safety RulesTraining PreparationTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Unpacking Carton See Fig Install Handle See Figs , 4,Connect Shift ROD See Fig Attach Clutch Cable See FigRemove Tiller from Crate Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation Tine Operation with Wheel Drive HOW to USE Your TillerForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedCultivating TurningTo Transport Before Starting EngineTo Start Engine See Fig ADD GasolineTilling Hints See Fig Adjust Wheels for Cultivating See FigsMaintenance Schedule MaintenanceGeneral Recommendations Lubrication Chart Before Each USEAIR Filter See Fig EngineCooling System See Fig CleaningMuffler Spark PlugTire Care Service and AdjustmentsTiller To Replace Ground Drive Belt See Figs Ground Drive Belt Adjustment S e e FigTine Replacement See Figs , 28 To Adjust Carburetor To Adjust Throttle Control Cable See FigOther StorageFuel System Engine OILTroubleshooting Points Handle Assembly Repair PartsMAINFRAME, Left Side KEY Part NO. NO. Description MAINFRAME, Right Side   Tine Shield Tine Assembly Decals 10.28.10 CL
Top Page Image Contents