Lennox Hearth 999995 manual Attaching To Tractor, Step

Page 16

ATTACHING TO TRACTOR

ATTACHING TO TRACTOR WARNING Manual background Never stand between tractor and rotary tiller while backing up tractor to the hitch.

STEP 1

Attach to tractor's category 1 three point hitch as described in the Tractor's Operator’s Manual.

STEP 2

Determine if the PTO shaft needs to be shortened.

NOTE:

Due to the many variations in the tractor hitch points and dis- tances between equipment gearbox input shaft and tractor PTO out put shafts, some combinations may require PTO shafts to be shortened as described by the following steps.

STEP 3

Raise and lower rotary tiller in order to locate the shortest distance be- tween equipment gearbox input shaft and tractor PTO output shaft. With the rotary tiller in the shortest distance position shut down the trac- tor and SECURELY BLOCK ROTARY TILLER IN POSITION.

STEP 4

Pull apart PTO shaft and attach outer section to tractor PTO output shaft. NOTE: Be sure to pull on PTO shaft section to ensure yoke has locked into place.

STEP 5

Place and hold inner PTO shaft section next to outer section and check if PTO shaft is too long. Each section should end approximately 3 inches short of reaching u-joint shield on the opposite section. If the shaft is too long measure 3 inches back from each u-joint shield and mark the other shaft section. Be sure to do this for both PTO shaft halves. NOTE: Do not cut PTO shaft sections at this time.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents OPERATOR MANUAL ROTARY TILLERPart No Page TO THE PURCHASER Customer InformationIt is the purchaser and/or operator’s responsibility to… CONTENTS ITEMSAFETY SIGNAL WORDSEQUIPMENT SAFETY GUIDELINES BEFORE PUTTING ROTARY TILLER INTO SERVICE ROTARY TILLER ASSEMBLY INSTRUCTIONS STEPSTEP STEP 4Replace and tighten the 1/2” pipe plug and clean away any excess oil. See Figure C Figure D Figure F Figure H Figure E Figure G FigureSAFETY TRAINING STARTING AND STOPPING SAFETY PREPARATIONOPERATIONAL SAFETY OPERATIONAL SAFETYcontinued TRANSPORT SAFETY ATTACHING TO TRACTOR ATTACHING TO TRACTORcontinued STEP SIZING PTO SHAFT STEP Figure 1-A Figure 1-B FigureOPERATING INSTRUCTIONS STEP STEP2MAINTENANCE NOTE: Do not grease the slip clutch assemblyMAINTENANCE SAFETY NOTE: Use only a grade Type II tube greaseSTORAGE SAFETY SAFETY SIGN LOCATIONS Top ViewPage Page Page Page Notes TILLER EXPLODED VIEW Part Name Part NumberTG-48 TG-60Ref No 22 PTO147122 TG SERIES OUT-BOARDHUB 184070TG SERIES SIDE GEARBOX TG SERIES SIDE GEARBOX PARTS LIST TG SERIES TOP GEARBOX ASSEMBLY TG SERIES TOP GEARBOX PARTS LIST 1. Limited Warranty 2. Warranty of Title3. What is Not Covered by This Limited Warranty 4. No Other Warranties
Top Page Image Contents