Lennox Hearth 999995 manual Rotary Tiller Assembly Instructions Step

Page 8

ROTARY TILLER ASSEMBLY INSTRUCTIONS

STEP 1

With rotary tiller still in crate, lay flat on a level surface. Cut banding straps on the two (2) upright crate posts.

STEP 2

Remove the top & upper side sections of the crate, leaving the rotary tiller resting on the bottom sec- tion.

STEP 3

Remove tie wire holding the PTO shaft and set aside PTO.

STEP 4

Attach tiller according to your tractors manual and using the instructions on pages 16 and 17.

STEP 5

Install tail back plate chain.

STEP 6

Install PTO shaft as outlined in the Attaching to Tractor Section, pg 16-19.

Note: The safety chains on the PTO shaft should be attatched to the tractor and tiller to prevent the plastic safety shield from rotating.

BEFORE PUTTING ROTARY TILLER INTO SERVICE

(IMPORTANT-INSTRUCTIONS PRIOR TO START UP) SHIPPED WITHOUT OIL IN GEAR BOXES AND WITHOUT GREASE IN GREASE FITTINGS. UNIT MUST BE SERVICED BEFORE USING.

•Fill Gearbox using gear oil (type GL5-85W 140 or Triple Zero Grease; which can be poured, and has "EP" i.e. "Extreme Pressure" additives.)

•For all Grease Fittings use TYPE/grade II tube grease.

STEP 1 Place rotary tiller so that the deck is secure and level.

STEP 2 Remove 1/2” Pipe Plug (Located at top of transmission gearbox). See Figure A.

STEP 3 Fill gearbox using gear oil until gearbox is approximately 1/2 full. See Figures B.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Part No ROTARY TILLEROPERATOR MANUAL Page TO THE PURCHASER Customer InformationIt is the purchaser and/or operator’s responsibility to… CONTENTS ITEMSAFETY SIGNAL WORDSEQUIPMENT SAFETY GUIDELINES STEP ROTARY TILLER ASSEMBLY INSTRUCTIONS STEPBEFORE PUTTING ROTARY TILLER INTO SERVICE STEP 4Replace and tighten the 1/2” pipe plug and clean away any excess oil. See Figure C Figure D Figure F Figure H Figure E Figure G FigureSAFETY TRAINING STARTING AND STOPPING SAFETY PREPARATIONOPERATIONAL SAFETY OPERATIONAL SAFETYcontinued TRANSPORT SAFETY ATTACHING TO TRACTOR ATTACHING TO TRACTORcontinued STEP SIZING PTO SHAFT STEP Figure 1-A Figure 1-B FigureOPERATING INSTRUCTIONS STEP STEP2MAINTENANCE NOTE: Do not grease the slip clutch assemblyMAINTENANCE SAFETY NOTE: Use only a grade Type II tube greaseSTORAGE SAFETY SAFETY SIGN LOCATIONS Top ViewPage Page Page Page Notes TILLER EXPLODED VIEW Part Name Part NumberTG-48 TG-60147122 22 PTORef No TG SERIES OUT-BOARDHUB 184070TG SERIES SIDE GEARBOX TG SERIES SIDE GEARBOX PARTS LIST TG SERIES TOP GEARBOX ASSEMBLY TG SERIES TOP GEARBOX PARTS LIST 1. Limited Warranty 2. Warranty of Title3. What is Not Covered by This Limited Warranty 4. No Other Warranties
Top Page Image Contents