STEP 4 Replace and tighten the 1/2” pipe plug and clean away any excess oil. See Figure C.
STEP 5 Remove 1/2” Pipe Plug (Located at top of side gearbox, See Figure D) and the 1/8" check plug (Located in side of the side gearbox).
STEP 6 Fill side gearbox using gear oil until the oil begins to overflow from the checkplug hole. See Figure E.
STEP 7 Replace and tighten the 1/2” vent plug and the 1/8" check plug. Clean away any excess oil. See Figure F.
STEP 8 Grease the grease fitting on the
CAUTION:
DO NOT over fill gearbox. This could cause damage to oil seals and can cause permanent damage to the gearbox. This issue will not be covered under warranty.
Figure A |
| Figure B |
|
|
|
|
|
|
Figure C
9