Lennox Hearth 999995 manual Sizing Pto Shaft Step, A -B Figure

Page 18

SIZING PTO SHAFT

STEP 1

Cutting the PTO shaft to length. NOTE: Be sure to cut equal lengths of each PTO shaft section. Clamp end of PTO shaft in a vice and cut off shield where marked. (Figure 1-A & 1-B)

STEP 2

Using cut section of the shield as a guide cut shaft off the same amount. (Figure 2)

STEP 3

Repeat steps 1 and 2 for other PTO shaft section.

STEP 4

Use a file to deburr PTO shafts. Clean up all chips, burrs and fil- ings from both ends of the PTO shaft.

Figure 1-A

Figure 1-B

Figure 2

Image 18

Contents ROTARY TILLER OPERATOR MANUALPart No Page TO THE PURCHASER Customer InformationIt is the purchaser and/or operator’s responsibility to… CONTENTS ITEMSAFETY SIGNAL WORDSEQUIPMENT SAFETY GUIDELINES ROTARY TILLER ASSEMBLY INSTRUCTIONS STEP BEFORE PUTTING ROTARY TILLER INTO SERVICESTEP STEP 4Replace and tighten the 1/2” pipe plug and clean away any excess oil. See Figure C Figure D Figure F Figure H Figure E Figure G FigureSAFETY TRAINING STARTING AND STOPPING SAFETY PREPARATIONOPERATIONAL SAFETY OPERATIONAL SAFETYcontinued TRANSPORT SAFETY ATTACHING TO TRACTOR ATTACHING TO TRACTORcontinued STEP SIZING PTO SHAFT STEP Figure 1-A Figure 1-B FigureOPERATING INSTRUCTIONS STEP STEP2MAINTENANCE SAFETY MAINTENANCENOTE: Do not grease the slip clutch assembly NOTE: Use only a grade Type II tube greaseSTORAGE SAFETY SAFETY SIGN LOCATIONS Top ViewPage Page Page Page Notes TILLER EXPLODED VIEW TG-48 Part NamePart Number TG-6022 PTO Ref No147122 TG SERIES OUT-BOARDHUB 184070TG SERIES SIDE GEARBOX TG SERIES SIDE GEARBOX PARTS LIST TG SERIES TOP GEARBOX ASSEMBLY TG SERIES TOP GEARBOX PARTS LIST 3. What is Not Covered by This Limited Warranty 1. Limited Warranty2. Warranty of Title 4. No Other Warranties