LX 2000PMEU
Important Information:
The Legend® Platinum II automatic pool cleaner comes ready to connect into a female threaded
The following are important facts to remember before installing and operating the Legend® Platinum II.
1.Always disconnect the Legend® Platinum II from the pool wall when cleaning or back washing the pool filter.
2.After cleaning or back washing, let the filtration system run for at least five minutes before reconnecting the Legend® Platinum II.
3.New plumbing lines should be flushed out before installing the Legend® Platinum II.
4.The Legend® Platinum II should not be used to remove plaster dust in new pools.
5.Always remove the Legend® Platinum II before swimmers enter the pool.
6.Always handle the Legend® Platinum II with care. Do not let children or pets play with the unit: it is not a toy.
7.Always pick up the Legend® Platinum II by the Vacuum Tube especially when lifting the unit out of the water.
8.Unless checking the wheel RPM, do not handle the Legend® Platinum II while it is operating.
9.Always remove the Legend® Platinum II from the pool before chemical shock treatments. As a rule, any pool water that is unsafe for swimming is unsafe for the Legend® Platinum II.
10.Carefully cut the feed hose following the instructions on Page 3.
By following these simple guidelines, you can help protect against injury and prolong the life of your Legend® Platinum II.
Before the Legend® Platinum II is installed, please take a moment to record the serial number. This number is located on the back of the Legend® Platinum II near the rear jet. You will be asked this number when you contact our Technical Support Department.
SERIAL #__________________________________
LEGEND® PLATINUM II INSTALLATION MANUAL • MANUEL D’INSTALLATION LEGEND® PLATINUM II