LEGEND ®
LL105PM / LL105PMG
LL105PMTGG / LL105PMTWW
LL105PMTRW / LL105PMTYW
Important Information:
The Legend® Platinum automatic pool cleaner comes ready to connect into a female threaded
The following are important facts to remember before installing and operating the Legend® Platinum.
1.Always disconnect the Legend® Platinum from the pool wall when cleaning or back washing the pool filter.
2.After cleaning or back washing, let the filtration system run for at least five minutes before reconnecting the Legend® Platinum.
3.New plumbing lines should be flushed out before installing the Legend® Platinum.
4.The Legend® Platinum should not be used to remove plaster dust in new pools.
5.Always remove the Legend® Platinum before swimmers enter the pool.
6.Always handle the Legend® Platinum with care. Do not let children or pets play with the unit: it is not a toy.
7.Always pick up the Legend® Platinum by the Vacuum Tube especially when lifting the unit out of the water.
8.Unless checking the wheel RPM, do not handle the Legend® Platinum while it is operating.
9.Always remove the Legend® Platinum from the pool before chemical shock treatments. As a rule, any pool water that is unsafe for swimming is unsafe for the Legend® Platinum.
10.Carefully cut the feed hose following the instructions on Page 3.
By following these simple guidelines, you can help protect against injury and prolong the life of your Legend® Platinum.
Before the Legend® Platinum is installed, please take a moment to record the serial number. This number is located on your warranty card and on the back of the Legend® Platinum near the rear jets. You will be asked for this number when you contact our Technical Support Department.
SERIAL #__________________________________
LEGEND® PLATINUM INSTALLATION MANUAL