Husqvarna HUV4210-GXP, HUV4210-EXP manual General Information, Front Bumper and Brush Guard

General Information

ýWARNING

•Use insulated tools when working near batteries or electrical connections. Use extreme caution to avoid shorting of components or wiring.

All vehicles:

•Wear safety glasses or approved eye protection when servicing the vehicle or battery charger. Wear a full face shield and rubber gloves when working on or near batteries.

•Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the vehicle or battery charger.

	AS SEEN FROM
	PASSENGER SIDE
	OF VEHICLE
	FRONT
	OF
	VEHICLE
	Remove
	negative
DISCONNECT BATTERY CABLES	cable first.
BEFORE WORKING ON VEHICLE

RUN

Place Tow / Run

W

switch in TOW

O

T

G

IN

N

R

A

W

Place TOW/RUN switch in the TOW

S

PO

position before disconnecting or

GNE

connecting battery cables.

NEG

1

P

O

S

NEG

S

PO

P

O

GNE

2

FRONT OF

S

VEHICLE

3

Remove negative (–)

4

cable first.

Figure 1 Gasoline Vehicle Figure 2 Electric Vehicle

GENERAL INFORMATION

This manual features two models: the electric vehicle and the gasoline vehicle. Throughout this manual, important features unique to each model are highlighted. We urge the owner/operator to read and understand this manual, and to pay special attention to the features specific to his/her vehicle(s).

FRONT BUMPER AND BRUSH GUARD

The front bumper and brush guard are an important part of the vehicle’s design for correct weight distribution. These parts are interchangeable, but one or the other must be installed at all times during vehicle operation to achieve proper balance (Figure 3 and Figure 4). See following WARNING.

ýWARNING

•Do not operate the vehicle without an installed front bumper or brush guard that is specifically designed and approved for use on this vehicle. Instability in the vehicle could cause serious injury or death.

2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 11