Husqvarna HUV4210-GXP, HUV4210-EXP manual Battery Charger Electric Vehicles

Page 38

Battery Charger – Electric Vehicles

BATTERY CHARGER – ELECTRIC VEHICLES

ýDANGER

•The charging area must be ventilated. Hydrogen level in the air must never exceed 2%. The total volume of air in the charging area must be changed five times per hour. Exhaust fans should be located at the highest point of the roof. Contact a local HVAC engineer.

•Do not charge the vehicle batteries with the vehicle covered or enclosed. Any enclosure or cover should be removed or unzipped and pulled back when batteries are being charged. An accumulation of hydrogen gas could result in an explosion.

ýWARNING

•Only trained technicians should repair or service the charger. Contact your nearest Husqvarna distributor/dealer.

•Each charger should have its own dedicated 15 or 20 ampere separately protected (circuit breaker or fuse) single phase branch circuit, in accordance with all applicable electrical codes for the location.

•Connect the charger AC supply cord to a properly grounded, three-wire outlet of the proper voltage and frequency as shown on the charger.

•Do not use an adapter to plug the charger with a three-prong plug into a two-prong outlet. Improper connection of the equipment-grounding conductor can result in a fire or an electrical shock.

•An extension cord or electrical outlet must accept a three-prong plug. Extension cord should be a three-wire No. 12 AWG (American Wire Gauge) or No. 14 SWG (British Standard Wire Gauge), and be as short as possible. The use of improper extension cord could result in fire or an electrical shock.

•Do not operate the charger if it has received a sharp blow, was dropped, or otherwise damaged in any way.

•Have worn, cut, or damaged power cords or wires replaced immediately.

•Do not use near fuels, grain dust, solvents, thinners, or other flammables. Chargers can ignite flammable materials and vapors.

•Do not expose to rain or any liquid. Keep the charger dry.

•Never push objects of any kind into the charger through cabinet slots. They may touch dangerous voltage points or cause an electrical short circuit that could result in fire or electrical shock.

•Do not connect a stationary charger to the receptacle if the charger cord, plug, or the vehicle receptacle is broken, damaged, or does not make a good electrical connection. Fire or personal injury can result. Have a qualified technician replace the parts.

•When the charger is on, the charger DC cord may be disconnected from the vehicle receptacle slowly. Jerking or pulling the DC cord out quickly could cause arcing and burning that could damage the plug and receptacle and could cause batteries to explode.

•Do not block or cover the charger ventilation slots. The slots provide ventilation and protect the charger from overheating.

•Do not allow clothing, blankets, or other material to cover the charger.

•Do not allow the charger to operate for more than 30 minutes at 19 or more amperes.

•Install surge arrestors on incoming AC power lines. Surge arrestors will help protect electrical components in the charger and on the vehicle from all but direct or close lightning strikes.

Page 36 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual

Page 37 Page 39
Image 38
Page 37 Page 39
Contents   6  2 Z Q H U V  0 D Q X D O Page USA Regular Maintenance Items Periodic Maintenance Items ForewordTable of Contents HUV4210-E Electric Vehicle Light HUV4210-G Gasoline Vehicle Diode Wiring Decal Choke Practice Safety DAN G E R Caut ION Safety DetailsGeneral Warnings Caut IONGeneral Warnings General Information Front Bumper and Brush GuardModel Identification BumperSee General Warnings on Controls and IndicatorsKEY Switch Gasoline VehiclesElectric Vehicles FORWARD/REVERSE ControlAccelerator Pedal Forward/Reverse Handle Gas VehiclePark Brake Pedal Battery Warning LightBrake Pedal Electric Vehicles OnlyTOW/RUN Switch LOW OIL Warning Light ChokeGasoline Vehicles Only Headlight Control PRE-OPERATION and Daily Safety ChecklistVolt Outlet Accessory Performance Inspection All VehiclesDriving Instructions Starting the Vehicle Stopping the Vehicle Parking and Leaving the VehicleWA RN I N G BED LatchTransporting on a Trailer Storage Electric Vehicles Preparing the Electric Vehicle for Extended StorageSee General Warnings on DAN G E R Returning the Stored Electric Vehicle to ServiceStorage Gasoline Vehicles Preparing the Gasoline Vehicle for Extended StorageFull Open on Position Viewed from Selector Side of Valve Maintenance Returning the Stored Gasoline Vehicle to ServicePeriodic Service Schedules Periodic Service Schedule Electric Vehicles Regular Interval ServicePeriodic Service Schedule Gasoline Vehicles Periodic Lubrication Schedules Periodic Lubrication Schedule Electric VehiclesPeriodic Lubrication Schedule Gasoline Vehicles Lubrication Points Gasoline VehiclesBatteries Electric Vehicles Battery CareVehicle Controller Electric Vehicles Batteries Electric Vehicles Battery Charger Electric Vehicles Charging Batteries Plug and Receptacle Correct Insertion of Charger DC PlugBattery Gasoline Vehicles Receptacle Fuse LinkGasoline Battery Electrolyte Level Engine OIL and Filter Change Engine OIL Gasoline VehiclesEngine OIL Level Check Engine Oil Drain Plug and Pan OIL Viscosity Remove Engine Oil FilterFueling Instructions Gasoline Vehicles Gasoline Vehicle for Extended Storage onSubsequent Owner Registration Cleaning the VehicleAccessories Vehicle Specifications SpecificationsEXP GXP Warranty Information Warranty Limitations Husqvarna Limited Warranty Exclusions California Emission Control Warranty Statement Your Warranty Rights and Obligations0UBLICATION 0ARTT.UMBER 603 00 DITIONT#ODE 0705B0705A
Top Page Image Contents