Storage – Gasoline Vehicles
2.4. Plug the fuel tank vent nipple so that it is air tight. We recommend using a
3.Disconnect the battery cables, negative
4.Batteries should be clean and free of corrosion. Wash tops and terminals of batteries with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse solution off bat- teries. Do not allow this solution to enter the batteries. Be sure terminals are tight. Let the terminals dry and then coat them with Battery Terminal Protector Spray (Husqvarna 603 00
CLOSED (OFF) POSITION
(SELECTOR IS ALIGNED
WITH OFF MARKINGS ON THE SIDES OF VALVE)
OFF | OFF |
VIEWED FROM SELECTOR
SIDE OF VALVE
Figure 16 Fuel Shut-off Valve – Closed Position
FULL OPEN (ON)
POSITION
VIEWED FROM SELECTOR
SIDE OF VALVE
Figure 17 Fuel Shut-off Valve – Open Position
PARTIALLY CLOSED
POSITION
VIEWED FROM SELECTOR
SIDE OF VALVE
Figure 18 Fuel Shut-off Valve –
Partially Closed Position
5.To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the engine through the spark plug hole. Rotate engine crankshaft by hand several times, then install the spark plug and tighten to 20
6.Adjust tires to recommended tire pressure. See Vehicle Specifications on page 46.
7.Perform semiannual periodic lubrication. See Periodic Lubrication Schedules on page 32.
8.Thoroughly clean front body, rear body, seats, engine compartment, and underside of vehicle.
9.Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
2006 Husqvarna | Page 27 |