Crown Audio CP660 operation manual Wire Your System 3.6.1 Stereo Mode, Bridge-Mono Mode

CP660 Power Amplifier

3 Setup

3.6Wire Your System 3.6.1 Stereo Mode

Typical input and output wiring is shown in Figure 3.6.

INPUTS: Connect input wiring for each channel. Maintain proper polarity (+/-) on input connectors.

OUTPUTS: Maintain proper polarity (+/-) on output connectors.

Connect Channel 1 positive (+) speaker load to Channel 1 positive (red) terminal of amp; repeat for negative (-). Repeat each channel wiring as for Channel 1.

3.6.2 Bridge-Mono Mode

Typical input and output wiring is shown in Figure 3.7.

INPUTS: Connect input wiring to lower- numbered channel only for each channel pair.

NOTE: Crown provides a reference of wiring pin assignments for commonly used connector types in the Crown Amplifier Application Guide (Section 1.21.) available at www.crownaudio.

OUTPUTS: Connect the speaker across the red binding post of each channel pair. Do not use the black binding posts of the channel pair when the pair is being operated in Bridge- Mono mode.

NOTE: Set the level control for the higher-numbered channel of the chan- nel pair to zero (0) when operating the channel pair in Bridge-Mono mode, as the lower-numbered level control works both channels.

Figure 3.6. System Wiring, Stereo Mode

Figure 3.7. System Wiring, Bridge-Mono Mode

page 8 Operation Manual