Harbor Freight Tools Complete Guide to the Torsion Key Tool and Cutter Guard for Biscuit Joiner

INSTALLING AND USING THE CUTTER GUARD

1.This machine comes with a Cutter Guard (800) that can be used with the router, shaper or drilling opperations. To attach the guard lower and lock the quill to the desired height. Press the Cutter Guard (800) up onto the quill. Tighten it in place using the nut and bolt pre-installed into the guard. (See Figure 1 below)

2.The guard can be pulled up out of the way when needed. (See Figure 2 below)

FIGURE 1 FIGURE 2

Bolt and nut that tightens the Cutter Guard

Cutter Guard (800)

TO SET UP THE LATHE

1.Insert the Lathe Spur Drive Center in the 3/4” R-8 Collet. Insert the Collet into the Quill, and tighten the Drawrod.

2.Insert the Tailstock into the mounting holes on the right of the machine. Lower the Tailstock to its lowest position until the Tailstock Collars touch the Support Bracket. Tighten the Hand-Twist Lock between the posts to secure the Tailstock. Then place the Morse Taper #2 Cup Center in the Tailstock to support the workpiece at the Tailstock end.

3.To mount the workpiece, lock the Powerhead and advance the Quill Feed to engage the workpiece between the Lathe Spur Drive Center and Cup Center.

After firmly seating the workpiece between the Spur Drive and Cup Center, relax the Quill slightly and lock the Quill Feed.

SKU 96067 For technical questions, please call 1-800-444-3353. Page 31