Page 27SKU 96067 for technical questions, please call 1-800-444-3353.
to.instaLL.tHe.Rip.fenCe.and.top.GUaRd
Slide the Rip Fence onto the front and back Tubular Guides, and align the Rip
Fence with the edge of a table slot. Then tighten the front Lock.
(see.figure.M.and.assy..diagram,.page.50.)
Align the mounting hole at the rear of the Top Guard with the threaded mounting
hole at the rear of the Table. Then tighten the Handle to secure the Top Guard in
place. (see.figure.M.and.assy..diagram,.page.50.)
1.
2.
fiGURe.M
to.instaLL.tHe.MiteR.GaUGe
Remove the Knurled Knob from the mounting post on the Miter Gauge. Slip the Clamp
into the slot on the Miter Gauge Handle. Then, reinstall the knurled Knob. Make sure to
screw the knurled Knob down through the Clamp to hold it in place. (see.figure.n.and.
assy..diagram,.page.56.)
fiGURe.n