5.If the Table is not perfectly squared with the Drill Bit, adjust the Table Stops with a wrench.
6.Recheck the Table’s 90 degree setting, and correct as needed.
TO ALIGN THE LATHE TAILSTOCK WITH THE POWERHEAD
1.Install the Drill Chuck/Drill Bit in the Horizontal Boring Tool. Make sure the Drill Bit is straight and long.
2.Remove the saw Table and Extension Table from the machine. Then mount the Tailstock with the Tail Center installed.
3.With the Drill Bit tip and Tail Center almost touching, check their alignment.
4.To vertically align the Drill Bit and Tail Center, raise or lower the Tailstock. Once aligned, loosen, position, and tighten the Collar.
5.To horizontally align, use an allen wrench to loosen the Socket Head Capscrew. Move sideways for alignment. Then retighten.
SKU 96067 | For technical questions, please call | Page 37 |
