TO ALIGN THE SAW TABLE TO THE SAW BLADE
1.Set up the machine with the Table in place and the Saw Blade/Arbor installed.
2.Set the Table Trunnion to zero.
3.Place the Miter Gauge in the Table Slot closest to the Saw Blade.
4.Hold a pencil against the face of the Miter Gauge while touching the face of the Saw Blade. As you rotate the Saw Blade, the high spot on the Blade will push the pencil away. Mark the high spot with chalk or a felt marker.
5.Reposition the pencil, the Miter Gauge, and the high spot on the Saw Blade together at the infeed end of the Table.
6.Rotate the Saw Blade, and bring the Miter Gauge and the high spot together at the infeed end of the Table. Make sure to keep the pencil in the same spot against the Miter Gauge.
7.The Table is aligned if the pencil tip touches the Saw Blade with the same touch and in the same place all the way around the Blade. The Table is not aligned if the Saw Blade pushes the pencil or there is a gap between the pencil tip and Blade. If the Table is not aligned, loosen all four Capscrews attaching the Table to the Trunnions. Adjust the Table. Then repeat Steps #2, #3, #4, #5, #6. Once alignment is achieved, tighten all four Capscrews.
TO ALIGN THE SAW TABLE 90 DEGREES TO THE SAW BLADE
1.Hold a
2.If the Table is not 90 degrees to the Saw Blade loosen the front and back Trunnion Handles.
3.Move the Table enough so the
4.Use Phillips screwdriver to reset the Trunnion’s 0 Degree Indicator to zero.
5.Loosen the Trunnion Locks and slightly move the Table. If the Table does not automatically stop at 0 degrees use a small screwdriver to adjust the Setscrew stop. The Table should stop at 0 degrees each time.
SKU 96067 | For technical questions, please call | Page 34 |
