Knobs. Failure to do so could cause the Powerhead and/or Carriage to drop down along the Way Tubes, causing possible personal injury and/or damage to the machine.
5.Mount the Drill Chuck by inserting it into the 3/4” Collet. Then tighten the Drawrod.
6.IMPORTANT: Never allow the Drill Bit to drop, plunge or cut more than 2” below the drill Insert hole. There is a Support Bar just under the Table surface.
FIGURE P
TO SET UP THE HORIZONTAL BORING TOOL
1.Insert the Drill Chuck (mounted on its Arbor) into the Quill and tighten the Drawrod. Then position the Table below the drill center and move the Table and Carriage toward the Powerhead. (See Figure Q.)
FIGURE Q
SKU 96067 | For technical questions, please call | Page 29 |
