TO ADJUST THE SAW TABLE’S 45 DEGREE STOP
1.Loosen the Trunnion Handle and move the Table toward 45 degrees.
2.Push on the Auto Stop Pin. If the Table does not stop at 45 degrees, move the Table back toward 0 to allow room to adjust the 45 Degree Stop Pin.
3.Make a slight adjustment to the Stopscrew and recheck the Stop. Repeat this procedure until it stops at exactly 45 degrees.
TO ALIGN THE MITER GAUGE
1.Place the Miter Gauge in the Table Slot closest to the Saw Blade.
2.Place a
3.Loosen the Miter Gauge Handle. Then move the face of the Miter Gauge so the
4.Use a screwdriver to reset the pointer to 0 degrees.
5.Pull the Stop Rod out and use a screwdriver to adjust the Stop Rod to 0 degrees.
6.To set the Miter Gauge at 45 degrees, pull out the Stop Rod and rotate the Miter Gauge face 45 degrees. Then place the 45 degree angle between the Miter Gauge face and Saw Blade.
7.When both angle edges are flush with the Miter Gauge face and Saw Blade adjust the 45 Degree Setscrew.
8.Place the Miter Gauge in the channel facing the opposite direction. To set another 45 degree stop, repeat Steps #6 and #7.
TO ALIGN THE EXTENSION TABLE 90 DEGREES TO THE SAW BLADE
1.Remove the saw Table from the Carriage. Move the Carriage and Powerhead all the way to the right.
2.Install the Extension Table with the top just above the Saw Blade Arbor. Then tighten the Handle Clamp.
3.Place the Miter Gauge in the Table Slot. Hold a pencil against the face of the Miter Gauge while touching the face of the Saw Blade. As you rotate the Saw Blade, the high spot will push the pencil away. Mark the high spot with chalk or a felt marker.
SKU 96067 | For technical questions, please call | Page 35 |
