Page 4SKU 96067 for technical questions, please call 1-800-444-3353.

speCifiCations
Electrical
Requirements
120 VAC / 7.5 A / Single Phase/15 Amps at full load
1.5 HP Motor Power Cord Type: 14 AWG x 3 C / 8’ Long
Power Switch Type: 2-Position Key Switch
Machine Features Table Saw / Disc Sander / Boring Machine
Lathe / Drill Press / Router & Shaper / Mill Machine
Accessories
Sanding Disc Assy. (Qty. 1) / Drill Press Insert (Qty. 1) / Router (Qty. 1)
Air Breather Mask (Qty. 1) Earplug Set (Qty. 1) / R8 Collet (Qty. 1)
Drawbar Handle (Qty. 1) / Wood Turning Faceplate (Qty. 1) / Dead
Center (Qty. 1)
Center Cup (Qty. 1) / Tension Wrench (Qty. 1) / Wrench Nut (Qty. 1)
Saw Arbor (Qty. 1) Lathe Tool Rest & Post (Qty. 1) / Shaper Arbor (Qty. 1)
Rip Fence (Qty. 1) / Miter Gauge Assy. (Qty. 1) / Upper Saw Guard Assy.
(Qty. 1) Extension Table Assy. (Qty. 1) / Spindle Guard (Qty. 1)
11-7/8” Disc Grinding Pads (Qty. 2)
Lathe Swing/Taper 17-5/16” (440mm) / #2 Morse Taper
Quill Travel 4-15/16” (125mm)
Distance Between
Centers 33-7/8” (860mm)
Vertical Mill 20-7/8” (530mm)
Maximum Depth of Cut 3-15/16” (100mm)
Taper of Spindle Bore A M.T. #5
Drilling Capacity 5/8” (16mm)
Disc Sander 12” Diameter
Wooding Cutting
Blade Size 10” or 12”
Speed Range Variable 32 to 7200 RPM
Table Size 23” L x 17” W x 2” H
Hole Through
Spindle Bore B 29/32” (23mm)
Overall Size 68.5” x 21.6” x 40.7”
Net Weight 456 Pounds

note:..this.tool.is.pre-wired.with.a.120.v.power.cord.and.plug...this.tool.is.dual.

voltage.(120v/220v)...Converting.this.tool.to.220v.should.only.be.done.by.a.

certied electrician.