Page 28SKU 96067 for technical questions, please call 1-800-444-3353.
to.instaLL.tHe.disC.sandeR
Insert the Sanding Disc Arbor into the Collet, and insert the Collet into the Quill.
Then tighten the Drawrod. Move the saw Table to about 1/16” from the sanding
surface. Adjust the height of the Table to about 1” below the centerline of the
Disc Sander. (see.figure.o.and.assy..diagram,.page.53.)
note: If your workpiece requires beveled sanding, tilt the Table to the desired
angle. Then adjust the Table’s inside edge height so that it is still about 1” below
the centerline of the Disc Sander. (see.figure.o.and.assy..diagram,.page.53.)
1.
2.
fiGURe.o
to.set.Up.tHe.veRtiCaL.dRiLL.pRess
Mount the saw Table and tilt it 90 degrees. Move the Powerhead and Carriage
into the approximate positions you will need for the drilling task at hand. Then
lock the Powerhead and Carriage in place.
(see.figure.p,.next.page.)
Loosen the two Locking Knobs on the Powerhead Support Bracket. Lift the
machine into the vertical Drill Press position. Firmly tighten the Vertical Locking
Knob on the Tailstock Support Bracket.
(see.figure.p,.next.page.)
Remove the saw blade table Insert and install the drill Insert. Adjust the
Powerhead and/or Carriage to the exact position you need. Then, make sure to
retighten all Locking Knobs. (see.figure.p,.next.page.)
CaUtion!..When moving the Powerhead or Carriage while the machine is in the
vertical position, make sure to hold the Travel Knob while loosening the Locking
1.
2.
3.
4.