Powermate PMC496751 manual Electric Start, Battery Kit Parts List, Battery Removal & Installation

Page 4

ELECTRIC START

This generator model is provided with both electric start and recoil start capabilities. The charger is a low amperage (1A) maintenance type charger. It will charge your battery as your generator runs. Avoid prolonged cranking, as it can damage the engine.

The battery provided is a nominal 12 volt sealed rechargeable lead-acid battery and can be operated in any position without leakage. It complies with non-spillable battery regulations. Its convenient size offers a 30% reduction over conventional batteries.

Length = 7.14 inches, Width = 3.03 inches, Height = 6.59 inches, Weight = 12.56 lbs 18AH Rating

UL Recognized

Battery Kit Parts List

 

 

Item

Description

 

Qty

 

 

 

 

 

 

A

 

*Bolt, M5 x M12

2

B.

*Nut 5MM

2

C.

*Washer Flat M5

2

*These are standard parts available at your local hardware store.

Note: Brand New Generators are shipped with the Battery Connections disconnected. The Positive and Negative Terminals must be connected to the Battery before the Electric Start Feature will work.

Initial Battery Connection - Refer to the Installation Instructions Below.

Battery Removal & Installation:

Removal: Remove the nut and bolt from the negative and positive post, being careful not to short across the terminals. (Shorting the terminals together can cause sparks, damage to the battery or generator or even burns or explosions.)

Always abide by the safety warnings provided with the battery. Remove the battery and re-cycle and dispose of properly.

Do not short-circuit the battery terminals.

Do not charge in a sealed container.

Keep sparks, flame away.

Installation:

Hook up the new battery, or re-install the new battery, as follows: Place the battery in the position provided. Connect the Red 10 Gauge wire to the positive (+) terminal and the Black 10 Gauge wire to the negative (-) terminal with the bolt, nut, and washer provided. Make sure all connections are tight. Your battery is now connected and ready for use. Turn the start rocker switch to the on position and push the start button to crank the engine.

Note: Be sure Oil has been added to the engine as specified in the Owner's Manual.

 

 

 

4

English

 

 

 

Image 4
Contents PMC496751 Limited Warranty Engine On/Off Switch Engine Start Button120 V, 20 Ampere Duplex Receptacle 120/240 V, 30 Ampere Twistlock ReceptaclePortability KIT Installation Wheel InstallationFoot Installation Handle InstallationBattery Removal & Installation Battery Kit Parts ListElectric Start Warranted Parts Prise à verrouillage de 120/240 V, 30 a Prise double de 120 V, 20 aDisjoncteurs Linstallation DE KIT DE Transport Installation DES RouesInstallation DU Pied Pose DE LA PoigneeListe des pièces du nécessaire de batterie Démarrage ÉlectriqueDépose et pose de la batterie Couverture DE Garantie DU Fabricant Receptáculo dúplex de 120 voltios, 20 amperes Panel DE ControlInterruptor Instalacion DEL Juego DE Transport Instalación DE LA ManijaLista de piezas del kit de batería Arranque EléctricoExtracción e instalación de la batería Cobertura DE LA Garantía DEL Fabricante Part Description Descripción QTYPart Description Descripción QTY Airport Road Box Kearney, NE Fax