Subaru Robin Power Products R1700i service manual Checking Functional Members, （1）STATOR

4-4) CHECKING FUNCTIONAL MEMBERS

（1）STATOR

Measure the winding wire resistance. Check the resistance of the wires that comes out from the stator using a tester, referring to the following table.

NOTE: When measuring according the numerical value shown in the chart, tolerance should be considered because the inaccuracy of the tester. If an accurate value is needed, measure by electric resistance using an Ohm-meter.

While doing this, use caution to avoid contact resistance.

Generator wire resistance		Unit；Ω
AC 120V	AC 230V	AC 240V
Color of the wires Specification	Specification	Specification

	Red-Blue	1.2	4.2	4.2
4P Connector (AC output line)	Blue-White	1.2	4.2	4.2
	White-Red	1.2	4.2	4.2
Diode Rectifier Connector	Yellow-Yellow/Blue	0.2	2.1	2.1
（2）INVERTER UNIT
Check if there is no color change or blister on the
filling resin, and confirm that there is no damage or
color change in the electrical parts, electrical wires,				White
or the connectors.
			a	c
And, check the resistance at the 2P connector for
			b	Red
AC output and at the 4P connecter for the stator				d
			Stator wire
wire terminals.
			terminal	2P connector
				for AC output

Stator wire Terminal

			Apply red needle of the circuit tester
			a	b	c	d
needleblack	testercircuit	a	ーーー	5 MΩ～	4 MΩ～	4 MΩ～
		b	2.5 MΩ～	ーーー	10 MΩ～	10 MΩ～
Apply	of the	c	2.5 MΩ～	10 MΩ～	ーーー	10 MΩ～
		d	2.5 MΩ～	10 MΩ～	10 MΩ～	ーーー

2P Connector for AC output

	Red	White
Red	ーーー	0.57 kΩ
White	0.57 kΩ	ーーー

– 15 –