8) Installthecamshaft.
NOTE: Apply oil or grease to the inside of oit seal for t h e gear case cover. |
| |
NOTE: Set the match mark of the camshaft so as to fit to t h a t of the crankgear. Side clearance is to be adjusted to | r | |
0.1 | ||
|
Fig. 41 | Fig. 42 |
9)Assemblethe oil pump and the governor.
6x 2 0 7 T b o l t . . . . . . . . . . . . 2 pcs. Spring washer . . . . . . . . . . . . 2 pcs.
NOTE: Thehole in the oil pump coveris to face downward.
NOTE: Check if the governorsleeve moves smoothly. Outer surfaceof t h e trochoid pump must face thecase side. (See Fig. 43.)
[Tightening torque: 80 - 100
\
the10) Assemble | gear case cover. | Fig. 43 |
8 x 5 7T bolt, . . . , . . . . . . . . 4 pcs.
Springwasher . . . . . . . . . . . . 4 pcs.
NOTE: When the pin is replaced, apply "Three Bond" at theboth ends of the pin for cranking. This pin locates a t t h e top of the camshaft.
8 x 65 7T bolt . . . . . . . . . . . . 3 pcs.
Spring washer . . . . . . . . . . . . 3 pcs.
NOTE: Check if the governor link operates.
[Tightening torque: 200 - 230
- 23 -