Commercial Audio Series Mixers
2 Setup
2.1 Installation
CAUTION: Before you begin, make sure your mixer is disconnected from the power source, with the power switch in the “off” position and all level controls turned completely down (counterclockwise).
Use a standard
You may also stack mixers without using a cabinet, or you may place a single mixer on a surface.
NOTE: When transporting in a rack, mixers should be supported at the front and back.
The side walls of the rack should be a minimum of two inches (5.1 cm) away from the amplifi er sides, and the back of the rack should be a minimum of four inches (10.2 cm) from the mixer back panel.
2.2 How to Attach Rack Ears
1. Locate the two rack ears supplied.
2.See Figure 2.2. Remove the two screws from each side of the chassis near the front.
3. Place a rack ear fl ush with the right front of the chassis.
4.Insert a screw that you removed into the bottom hole of the rack ear and chassis. Screw it in.
5.Insert a screw that you removed into the top hole
of the rack ear and chassis. Screw it in.
6. Repeat steps
Figure 2.2 How to Connect Rack Ears
| 1 |
| 2 |
| 3 |
| 4 |
| 5 |
| 6 |
| 7 |
| 8 |
| SPI | CLIP |
| SPI | CLIP |
|
| 10 |
| 10 |
| 10 |
| 10 |
| 10 |
| 10 |
| 10 |
| 10 |
|
| 10 |
|
| 10 | POWER |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
5 | 15 | 5 | 15 | 5 | 15 | 5 | 15 | 5 | 15 | 5 | 15 | 5 | 15 | 5 | 15 | 5 |
| 15 | 5 |
| 15 |
|
0 | 20 | 0 | 20 | 0 | 20 | 0 | 20 | 0 | 20 | 0 | 20 | 0 | 20 | 0 | 20 |
| 0 | 20 |
| 0 | 20 |
|
B | T | B | T | B | T | B | T | B | T | B | T | B | T | B | T |
| MASTER 1 |
| MASTER 2 |
| ||
17.3In.
43.8cm
1.7In.
4.3cm
10.7In.
27.18 cm
11.9In.
30.2cm
Figure 2.1 Dimensions
page 8 | Operation Manual |