2.6 Installation Instructions
The V200s should be mounted on a din rail plate. A din rail sliders and locking connectors are provided with each V200 unit for proper installation.
Environmental Considerations:
Make sure that the unit is installed correctly and that the operating limits are followed (see Specifications for V200). Do not operate the V200 in areas subject to explosion hazards due to flammable gases, vapors or dusts. A V200 should not be installed where fast temperature variations are present. Highly humid areas are also to be avoided. High humidity causes condensation of water in the unit.
Location Considerations:
Care should be taken when locating equipment behind the V200 to ensure that AC power wiring, PLC output modules, contactors, starters, relays and any other source of electrical interference are located away from the V200. Particular care should be taken to locate variable speed drives and switching power supplies away from the V200.
Panel Mounting
This section presents the dimensional sketches and din rail sliding for V200 (V200) models. (All dimensions are in mm and drawing are not to scale.)
V200 PLCs are shipped with a DIN rail slider & locking connector attached to the unit. User can use the unit with or without DIN rail slider.
Dimensional Details:
Page 57
