TROUBLESHOOTING
Reread the sections of this manual to make sure you have completed system
If you are unable to solve the problem, contact the dealer from whom you purchased the system for as- sistance.
PROBLEM | SOLUTION |
|
|
DISTORTION | Reduce audio gain on transmitter by adjusting |
distorted at medium to high input levels | the gain controls. |
|
|
HISS - System seems to produce a "hiss" which | Check the gain settings on the transmitter and |
is undesirable. | the volume control on the receiver. They may |
| be too low. |
|
|
DROPOUTS - When moving around the area | Make sure the antenna is connected and fully |
in which you will be using the system there | extended. Follow the location suggestions on |
seem to be locations where the signal | page 15. Change the location of the transmitter |
"swooshes" or completely disappears. | antenna or avoid the bad area with the receivers. |
|
|
INTERFERENCE - System picks up signals | Make sure the Telex |
other than the | will usually eliminate the interference signal. |
| If problem persist with the transmitter "ON", try |
| changing to another channel. |
|
|
REDUCED DISTANCE - System doesn't oper- | Receiver Battery is possibly in need of replace- |
ate as far as it once did. System doesn't' operate | ment. Transmitter antenna possible located in- |
as well as you think it should. | correctly. Receiver not tuned properly. |
|
|
BATTERIES DON'T LAST | If using "throw away" batteries make sure they |
| are alkaline. If using |
| metal hydride batteries make sure they were |
| fully charged when yo are using them and fully |
| drained when you are done before recharging |
| them. |
|
|
HUM - Audio System emits hum or buzz thru | Locate Transmitter away from the audio equip- |
speakers and sound enhancement receiver. | ment. |
|
|
Transmission sounds compressed on | E.D.R. function may be engaged on the |
| See setting E.D.R. function on page 9. The |
| E.D.R. feature can only be used with the |
| and must be active on both transmitter and re- |
| ceiver to be effective. |
|
|
SET button does not work, cannot change chan- | Lock Out is engaged, press and hold UP and |
nel | DOWN buttons until the padlock symbol disap- |
| pears. |
|
|
|
|