Equipment SET-UP and Operation, TT-16 Specifications

	TT-16 Specifications
Audio Input: Female XLR
RTS 1 Selected	Line impedance 200 Ω / Level adjustable
RTS 2 Selected	Line impedance 200 Ω / Level adjustable
Telex Selected	Line impedance 300 Ω / Level adjustable
Unbalanced Audio Input	10K Ω input impedance/10 mV-1.0 VRMS input range
RF Power Switch	50mW in “Hi”, approx. 5mW in “Low”
AGC Range	30 dB
Signal-to-noise Ratio:
Normal	58 dB
EDR Enabled	77 dB
Pre-Emphasis	115μS
Maximum Deviation	±25 kHz
Frequency Control Crystal	+/-.005% tolerance
Available Frequencies	See Table 1, page 2
Max. Transmitter Output Power	50 mW
Power Requirements	12-15V, AC or DC @ 300 mA
Dimensions	7 ½"W x 1 3/4"H x 6 7/8"D
FCC ID	B5DM524

EQUIPMENT SET-UP AND OPERATION

TT-16 SYNTHESIZED

TRANSMITTER

UNPACKING: Unpack your Wireless IFB system. If there are any damages or shortages, refer to the "War- ranty Service Information" card.

TT-16 TRANSMITTER LOCATION: Select a suit- able location for the TT-16 Transmitter. Try to keep a clear, unobstructed path between the transmitter and receiver and allow plenty of free space around the transmitter antenna.

ANTENNA CONNECTIONS: Connect the tele- scoping antenna to the rear panel ANTENNA jack.

For best results, the antenna should be vertically aligned. Tighten the knurled ring to hold the antenna in place, and extend the antenna to full length.

-6-

ANTENNA

REAR PANEL

Figure 6

Antenna Connection

POWER CONNECTION: Plug the AC power adapter into an electrical outlet. Plug the other end of the cord into the power input jack on the rear panel of the TT-16.