Antenna
+ 
-
Figure 7
Connecting Power
SYSTEM SET UP
All of the channel and input selection functions are accessed from the front panel. Press SET button once to begin System Setup. Whenever a function is flashing, the UP and DOWN buttons can be used to adjust it. Once set, the next function will start to flash. To access a specific function, press SET until the function is flashing, the features are accessed in the following order:
Channel
RF Power Output Unbalanced Level Adjust Balanced Input (RTS1/RTS2/Telex) Balanced Level Adjust
Channel Selection
Turn the
The LCD display will light up and show the Chan- nel, Audio Meter, Frequency (and E.D.R. if it has been enabled). Press the SET button once and Chan- nel letter will flash. Use the UP and DOWN Arrow buttons to select the desired channel
RF Power Selection
should be used for small to medium sized venues and whenever multiple systems are being used. Press SET when the power is set and the Unbalanced In- put level will flash.
Unbalanced Input And Level Adjustment
If the unbalanced audio input will not be used, with the "Unbalanced Audio Level" flashing use the DOWN button to set the level to OFF and press set to go to Balance Input Selection.
If the Unbalanced input will be used, connect the in- put now and apply audio content. With the audio content playing and "Unbalanced Audio Level" flashing, watch the audio meter. The peak signal should not go above the 0 dB segment, use the UP and DOWN buttons to adjust the input level so that the loudest input lights up the 0 dB segment. When the level is set, press the SET button and one of the input options will flash.
Balanced Intercom Input and Level Adjustment
With the Balanced Intercom Input selection flashing (RTS1, RTS2, or TELEX). Use the UP and DOWN buttons to scroll to the correct input. With the cor- rect input displayed, press SET and the "Balanced Audio Level" indicator will flash.
If the intercom audio input will not be used, with one of the Balanced Input options flashing press SET so the "Balanced Audio Level" is flashing. Use the DOWN button to set the level to OFF and press SET to end the setup session. When OFF is selected "Balanced Audio Level" will not be dis- played on the screen.
If the Balanced Input Selection will be used, then connect the input and apply audio content. With the audio content playing and "Balanced Audio Level" flashing, watch the audio meter. The peak signal should not go above the 0 dB segment, use the UP and DOWN buttons to adjust the input level so that the loudest input lights up the 0 dB segment. When the level is set, press the SET button and the Setup Session will end.
While the "RF Power" indicator is flashing, press the UP ARROW for HIGH and DOWN for NORM (the "RF Power" line will flash quickly and will disappear when SET is pressed). NORM power
NOTE: The