White Outdoor L-Syle warranty Augers, Drive Belt Replacement

Page 16

5 1

Maintaining

Your Snow

Thrower

Augers

The augers are secured to the spiral shaft with two shear pins and cotter pins. If the auger should strike a foreign object or ice jam, the snow thrower is designed so that the pins may shear. Refer to Figure 9.

If the augers will not turn, check to see if the pins have sheared. One set of replacement shear pins has been provided with the snow thrower. When replacing pins, spray an oil lubricant into shaft before inserting new pins.

Drive Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the plastic belt cover on the front of the engine by removing the two self-tapping screws.

NEVER replace the auger shear pins with anything other than OEM Part No.738-04124A replacement shear pins. Any damage to the auger gearbox or other components as a result of failing to do so will NOT be covered by your snow thrower’s warranty.

2

3

 

Drain the gasoline from the snow thrower, or place a piece of plastic under the gas cap.

Carefully pivot the snow thrower up and forward so that it rests on the auger housing.

2.Remove the frame cover from the underside of the snow thrower by removing four self-tapping screws which secure it.

3.a. Grasp the idler pulley and pivot it toward the right.

b.Roll the auger belt off the engine pulley.

c.Lift the drive belt off engine pulley.

4.Slip the drive belt off the pulley and between friction wheel and friction wheel disc.

• Remove and replace belt in the reverse order.

4

16

Image 16
Contents OPERATOR’S Manual MTD LLC, P.O. BOX 361131 CLEVELAND, OhioTable of Contents Chute clean-out tool is fastened to the top Your ResponsibilityTrainingPreparation Your Responsibility Restrict the useMaintenance & Storage OperationDo not modify engine Your ResponsibilitySetting Up Your Snow ThrowerSetting Up Your Snow Thrower Chute Clean-Out ToolShear Pin Storage Tire PressureOperating Your Snow ThrowerOperating Your Snow Thrower Starting The Engine Gas & Oil Fill-UpStopping The Engine Chute Clean-Out Tool To Engage DriveTo Engage Augers Recoil StarterShift Cable Chute Directional ControlMaking Maintaining Your Snow Thrower EngineLubrication Shave Plate and Skid ShoesAuger Belt Replacement Place a piece of plastic under the gas capDrive Belt Replacement Friction Wheel Removal Cracking and replace if necessaryPreparing Engine Off-Season StoragePreparing Snow Thrower Trouble Shooting Problem Cause RemedyStyle L Illustrated Parts List To order replacement Parts, contact Or visitStyle L 738-04194 Flange Shoulder Screw Style L Disc, Friction Wheel Page Page MANUFACTURER’S Limited Warranty for MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio 44136-0019 Phone