White Outdoor L-Syle warranty Setting Up Your Snow, Thrower

Page 6

3

Setting Up

Your Snow

Thrower

NOTE: All references

 

in this manual to the

 

left or right side of the

 

snow thrower is from

Figure 1

the operating position

only. Exceptions, if any,

 

will be specified.

 

IMPORTANT

This unit is shipped with the engine full of oil. After assembly, refer to the Tecumseh Engines manual packed separately with your snow thrower for fuel and oil fill-up details.

Figure 2

Figure 3

IMPORTANT: Two replacement auger shear pins are included with this manual (or stowed in the plastic handle panel). Refer to Augers on page 21 for more information regarding shear pin replacement.

 

1. Observe the lower area of the snow thrower to be

sure both cables are aligned with roller guides before

pivoting handle upward.

a. Pull up and back on upper handle as shown in Figure 1. Align upper handle with the lower handle.

b. Tighten hand knobs securing upper handle to lower handle.

2. If it’s not already attached from the factory, position the chute assembly (forward-facing) over the chute base. See Figure 2.

3. a. Insert the round end of the chute control assembly on the short tube of the chute assembly as shown in Figure 3.

b. Secure other end of the chute control assembly onto the chute support bracket.

4. Secure the round end of the chute control assembly to the chute assembly with wing nut provided. See Figure 4.

5. Check that all cables are properly routed through the cable guide on top of the engine. See Figure 4.

The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the snow thrower.

CAUTION: Prior to operating your snow thrower, refer to Auger Control Test on page 11. Read and follow all instructions carefully, and perform all adjustments to verify your snow thrower is operating safely and properly.

Figure 4

6

Image 6
Contents OPERATOR’S Manual MTD LLC, P.O. BOX 361131 CLEVELAND, OhioTable of Contents Chute clean-out tool is fastened to the top Your ResponsibilityTrainingPreparation Your Responsibility Restrict the useDo not modify engine Maintenance & StorageOperation Your ResponsibilitySetting Up Your Snow ThrowerShear Pin Storage Setting Up Your Snow ThrowerChute Clean-Out Tool Tire PressureOperating Your Snow ThrowerOperating Your Snow Thrower Gas & Oil Fill-Up Starting The EngineStopping The Engine To Engage Augers Chute Clean-Out ToolTo Engage Drive Recoil StarterShift Cable Chute Directional ControlMaking Lubrication Maintaining Your Snow ThrowerEngine Shave Plate and Skid ShoesAuger Belt Replacement Place a piece of plastic under the gas capDrive Belt Replacement Friction Wheel Removal Cracking and replace if necessaryOff-Season Storage Preparing EnginePreparing Snow Thrower Trouble Shooting Problem Cause RemedyStyle L Illustrated Parts List To order replacement Parts, contact Or visitStyle L 738-04194 Flange Shoulder Screw Style L Disc, Friction Wheel Page Page MANUFACTURER’S Limited Warranty for MTD LLC, P.O. BOX 361131 CLEVELAND, Ohio 44136-0019 Phone