Poulan 96198003301, 429264 Cover, Wheel Driver Retainer Ring, Wheel Lobe, Clutch Slide, Axle Lobe

Page 39

REPAIR PARTS SNOW THROWER - - MODEL NUMBER PP1150E27 (96198003301)

WHEELS

2

17

16

20

19 21

2				7
	3	4	5	6
2	1 01.15.001-A

			17						3	2
			17		23			4	3	1
		20		19			6	5
		16					6	5
	18	16			22		7
		15	18		22	9	7
		15	18			9	8
		24				10
		23			11	10
		23	21		11
		22
					12
					14
			14 13		13
		11	14 13
	10		12
8	9
			KEY	PART		DESCRIPTION
			NO.	NO.		DESCRIPTION
			1	405161		COVER
			2	184471		SHOULDER SCREW

312000045 RETAINER RING

4192126 WHEEL DRIVER

5182466 RETAINER RING

6	187622	WHEEL LOBE
7	194941	CLUTCH SLIDE
8	179139	SPRING
9	189282	SQUARE KEY
10	194940	AXLE LOBE
11	174697	THRUST WASHER

12193506X479 STEERING YOKE

13179148X479 STEERING BRACKET

1417490508 SCREW 5/16−18 X .50

15194943X008 PIVOT BRACKET

16194944X008 BELLCRANK

17181847 BELLCRANK PIN

1817600406 SCREW 1/4−20 X .375

19405077 STEERING LINK

20	700279	RETAINER
21	85179	RETAINER
22	193885	SPRING
23	182015	LEVER PIN
24	194939X008	PIVOT BRACKET

NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm

IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.

39

Image 39

Contents Snow Thrower Model NumberSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in CartonInstall Speed Control ROD See Figs Install Traction Drive Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotater Head See Fig Install Auger Control ROD See FigsCheck Tire Pressure Install Chute Deflector Remote Control See FigsIgnition KEY OperationKnow Your Snow Thrower PrimerRecoil auxiliary starter handle used for starting the engine Meets A.N.S.I. Safety RequirementsTo Control Snow Discharge See Fig HOW to USE Your Snow ThrowerStopping To USE Choke Control See FigTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigPower Steering Operation See Fig To Throw Snow See FigCheck Engine OIL Level See Fig To Adjust Skid Plates See FigBefore Starting the Engine Scraper BAR See FigIf Recoil Starter has Frozen Snow Throwing TipsTo Start Engine Before StoppingLubrication MaintenanceGeneral Recommendations Before Each USEEngine CleaningShear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute DeflectorTo Replace Belts See Fig Engine Speed To Adjust Cable Tension See FigTo Remove Wheels See Fig CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Service Notes 23 22 KEY Part Description Bearing Plug Auger HousingScraper BAR Auger BearingAuger 27 RH Auger 27 LHDeflector Spring Knob BlackPOP Rivet Shoulder ScrewRotator Head LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Cable Assembly Heat ShieldPivot Support Loop Handle LHLoop Handle RH Lower TubeHandle Knob SpacerRetainer Knob REDCarriage Bolt 5/16-18 X 155377 NUT 5/16-18 169675 Flood Headlight Wire HarnessConsole Panel Headlight BezelRepair Parts Snow Thrower - Model Number PP1150E27 Drive END Plate Speed Selector AssemblyDrive Plate Assembly Wheel HUB01.03.002-A Engine Mounting Plate ENGINE, B&SFrame 423185X428Idler Pulley Impeller BeltTraction Belt Idler ARM BracketCover Assembly Cable Bracket LH Cable Bracket RH Repair Parts Snow Thrower - Model Number PP1150E27 WheelsClutch Slide CoverWheel Driver Retainer Ring Wheel Lobe193071 Safety Ignition KEYDECAL, Instruction 181037DECAL, Danger DECAL, DANGER, DeflectorService Notes Service Notes Limited Warranty