If adjustment is necessary:
•Loosen the jam nut on the traction drive cable and thread the cable in or out as necessary.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
•Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap, be certain to remove it before operating the snow thrower.
Shift Rod Adjustment
To adjust the shift rod, proceed as follows.
•Remove the hairpin clip and slide the connector up to separate the upper shift rod from the lower shift rod. See Figure 11.
Shift Lever |
Ferrule |
Connector |
Upper Shift Rod |
Hairpin |
Clip |
Shift Arm |
Lower Shift Rod |
Figure 11
•Place shift lever in sixth (6) position.
•Rotate the shift arm counterclockwise (from the operator’s position) as far as it will go.
•Thread the upper shift rod downward until the elbow on its lower end aligns with the hole found in the lower shift rod.
•Reconnect the upper shift rod to the lower shift rod by reinserting the hairpin clip removed earlier and sliding the connector back down into place.
IMPORTANT: Make certain to check for correct adjustment of the shift rod as instructed under the heading Final Adjustments in Section 3 of this manual, before operating the snow thrower.
Drive Wheels
The wheels may be adjusted for two different methods of operation. The adjustment is made by placing the click pins in one of two different holes on the right side of the unit. See Figure 12.
Inside Hole |
in Axle |
Click Pin |
in Outside Hole |
Figure 12
One Wheel Driving— Insert the click pin only through the outside hole of the axle (NOT the rim) on the right side of the snow thrower. This position gives power drive to the left wheel only, making the unit easier to maneuver.
Both Wheels Driving— Insert the click pin through the hole in the hub of the rim and the INSIDE hole on the snow thrower’s right axle. This position is good for heavy snow as there is power drive in both wheels.
IMPORTANT: NEVER operate the snow thrower with the click pin inserted through both the RIM and the OUTSIDE HOLE in the axle. Doing so can result in serious damage to the drive system.
11