
Fuel Shut-off Valve
The fuel
Closed
under fuel tank, controls fuel flow
from the tank. Always make certain Open it is in the Open (vertical) position
before attempting to start the engine.
Throttle Control
The throttle control is located on the engine. It regulates the speed of the engine.
Safety Ignition Key
The safety ignition key must be fully inserted in the switch before the unit will start. Remove the ignition key when snow thrower is not in use.
IMPORTANT: Do NOT attempt to turn the key.
Primer
Choke
Rope
Ignition KeyStarter
ThrottleHandle
Control
Figure 7
SECTION 5: OPERATING YOUR SNOW THROWER
Gas And Oil Fill-up
IMPORTANT: Although your snow thrower comes shipped with oil already in the engine, you MUST check the engine oil level as instructed in the separate engine manual packed with your unit BEFORE starting the engine for the first time. Read instructions carefully
Service the engine with gasoline and oil as instructed in the separate engine manual packed with your snow thrower. Read instructions carefully.
WARNING: Never fill fuel tank indoors, with engine running or while engine is hot. Do not smoke when filling fuel tank.
Electric Starter
WARNING: The electric starter is equipped with a
120 volt AC household current. It must be properly grounded at all times to avoid the possibility of electric shock which may be injurious to the operator. Follow all instructions carefully. Determine that your house wiring is a
•When connecting the power cord, always connect cord to starter on engine first, then plug the other end into a
•When disconnecting the cord, always unplug the end from the
To Start Engine
IMPORTANT: If unit shows any sign of motion (traction or augers) with the controls disengaged, shut engine off immediately. Readjust as instructed under the heading Final Adjustments in Section 3 of this manual.
•Attach spark plug wire to spark plug.
•Make certain the fuel
•Make certain that both the auger control and the traction control are in the disengaged (released) position.
•Move throttle control up to FAST position. Insert ignition key into slot. See Figure 7. Be certain it snaps into place. Do not turn the key.
•Rotate choke knob to FULL choke position (cold engine start). If engine is warm, place choke in OFF position instead of FULL.
•Electric Start Only: Connect power cord to switch box on engine. Plug the other end of power cord into a
•Recoil Start Only: Push primer button two or three times when using recoil starter. If engine is warm, push primer button once only. See Figure 7.
NOTE: Always cover vent hole in primer button when pushing. Additional priming may be necessary for first
start if temperature is below 15oF.
8