Poulan 430429, 96198002801 owner manual Warranty

Page 42

WARRANTY

(9)Unapproved, add-on, modified, counterfeit and/or “grey market” parts may not be used to modify or repair a Husqvarna Consumer Outdoor Products NA, Inc. engine. Such use voids this ECS Warranty and shall

be sufficient grounds for disallowing an ECS Warranty claim. Husqvarna Consumer Outdoor Products NA, Inc. shall not be held liable hereunder for failures of any warranted parts of a Husqvarna Consumer Outdoor Products NA, Inc. engine caused by the use of such an unapproved, add-on, modified, counterfeit and/or “grey market” part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING: (New Phase III language inserted, but may not be necessary to use.)

I. For exhaust emissions, emission-related components include any engine parts related to the following sys- tems:

1.Air-induction system.

2.Fuel system.

3.Ignition system.

4.Exhaust gas recirculation systems.

II.The following parts are also considered emission-related components for exhaust emissions:

1. Aftertreatment devices.

2. Crankcase ventilation valves.

3. Sensors.

4. Electronic control units.

III.The following parts are considered emission-related components for evaporative emissions: 1. Fuel Tank.

2. Fuel Cap.

3. Fuel Line.

4. Fuel Line Fittings.

5. Clamps*.

6. Pressure Relief Valves*.

7. Control Valves*.

8. Control Solenoids*.

9. Electronic Controls*.

10. Vacuum Control Diaphragms*.

11. Control Cables*.

12. Control Linkages*.

13. Purge Valves.

14. Vapor Hoses.

15. Liquid/Vapor Separator.

16. Carbon Canister.

17. Canister Mounting Brackets.

18. Carburetor Purge Port Connector.

*As related to the evaporative emission control system.

IV. Emission-related components also include any other part whose only purpose is to reduce emissions or whose failure will increase emissions without significantly degrading engine/equipment performance.

42

Image 42

Contents Model Number Snow ThrowerSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Parts Packed Separately in Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Remove Snow Thrower from CartonInstall Speed Control ROD See Figs Install Traction Drive Control ROD See FigsUnfold Upper Handle Install Auger Control ROD See Figs Install Discharge Chute / Chute Rotator Head See FigInstall Chute Deflector Remote Control See Figs Check Tire PressurePrimer OperationKnow Your Snow Thrower Ignition KEYMeets A.N.S.I. Safety Requirements Recoil auxiliary starter handle used for starting engineHOW to USE Your Snow Thrower StoppingUsing the CLEAN-OUT Tool See Fig To Throw Snow See FigTo Move Forward and Backward See Fig Before Starting the Engine To Start EngineSnow Throwing Tips Before StoppingIf Recoil Starter has Frozen Maintenance Cleaning EngineChute Deflector Service and AdjustmentsTo Adjust Snow Thrower Height Shear Bolts See FigTo Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Remove Wheels See Fig Engine SpeedFuel System StorageOther Engine OILTroubleshooting Scraper BAR Auger HousingKEY Part Description Auger 27 LH23 22 KEY Part NO. NO. Description Auger Bearing Bearing PlugChute Weldment Deflector Control AssemblyDeflector Spring 15 420679 Service Part Deflector Control Deflector WeldmentCable Assembly Heat Shield LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Rotator HeadLower Tube Loop Handle LHLoop Handle RH Pivot SupportKnob RED SpacerRetainer Handle KnobShifter ROD TOP Impeller ROD AssemblyTraction ROD Assembly Shifter ROD BottomTorsion Spring Interlock SpringInterlock CAM Interlock StopSprocket Axle ShaftRoll PIN 3/16 Clik PINExploded Speed Selector AssemblyDrive Plate Assembly Rubber RingEngine Mounting Plate Frame427928X428 428685Idler ARM Bracket Impeller BeltTraction Belt Idler PulleyWheel Assembly LH 187833X421187865X421 Safety Ignition KEY 428498KEY Part NO. no 181037 DECAL, DangerDECAL, DANGER, Deflector KEY Part Description QTY Warranty MANUFACTURER’S Warranty CoverageII. Emission Control System Warranty Warranty Limited Warranty