Poulan P14530ES owner manual Troubleshooting

Page 19

TROUBLESHOOTING

See appropriate section in manual unless directed to an authorized service center/department.

PROBLEM

 

CAUSE

 

CORRECTION

Does not start

1.

Fuel shut-off valve (if so

1.

Turn fuel shut-off valve to OPEN position.

 

 

equipped) in OFF position.

 

 

 

2.

Safety ignition key

2.

Insert safety ignition key.

 

 

is not inserted.

 

 

 

3.

Out of fuel.

3.

Fill fuel tank with fresh, clean gasoline.

 

4.

Throttle in STOP position

4.

Move throttle to FAST position

 

 

(or ON/OFF switch is OFF).

 

(or ON/OFF switch to ON position).

 

5.

Choke in OFF position.

5.

Move to FULL position.

 

6.

Primer not depressed.

6.

Prime as instructed in the Operation section of this manual.

 

7.

Engine is flooded.

7.

Wait a few minutes before restarting, DO NOT prime.

 

8.

Spark plug wire is

8.

Connect wire to spark plug.

 

 

disconnected.

 

 

 

9.

Bad spark plug.

9.

Replace spark plug.

 

10.

Stale fuel.

10.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

11.

Water in fuel.

11.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

 

 

 

 

Loss of power

1.

Spark plug wire loose.

1.

Reconnect spark plug wire.

 

2.

Throwing too much snow.

2.

Reduce speed and width of swath.

 

3.

Fuel tank cap is covered

3.

Remove ice and snow on and around fuel tank cap.

 

 

with ice or snow.

 

 

 

4.

Dirty or clogged muffler.

4.

Clean or replace muffler.

 

 

 

 

 

Engine idles or

1.

Choke is in FULL position.

1.

Move choke to OFF position.

runs roughly

2.

Blockage in fuel line.

2.

Clean fuel line.

 

3.

Stale fuel.

3.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

4.

Water in fuel.

4.

Empty fuel tank & carburetor, refill with fresh, clean gasoline.

 

5.

Carburetor is in need of

5.

Contact an authorized service center/department.

 

 

adjustment or overhaul.

 

 

 

 

 

 

 

Excessive

1.

Loose parts or damaged

1.

Tighten all fasteners. Replace damaged parts. If vibration

vibration

 

augers or impeller.

 

remains, contact an authorized service center/department.

 

 

 

 

 

Recoil starter

1.

Frozen recoil starter.

1.

See “IF RECOIL STARTER HAS FROZEN”

is hard to pull

 

 

 

in the Operation section of this manual.

 

 

 

 

 

Loss of traction

1.

Drive belt is worn.

1.

Check / replace drive belt.

drive / slowing

2.

Drive belt is off of pulley.

2.

Check / reinstall drive belt.

of drive speed

3.

Friction drive wheel is worn.

3.

Contact an authorized service center/department.

 

 

 

 

 

Loss of snow

1.

Auger belt is off of pulley.

1.

Check / reinstall auger belt.

discharge or

2.

Auger belt is worn.

2.

Check / replace auger belt.

slowing of

3.

Clogged discharge chute.

3.

Clean snow chute.

snow discharge

4.

Augers / impeller jammed.

4.

Remove debris or foreign object from augers / impeller.

 

 

 

 

 

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Snow Thrower Model NumberSafe Operation Practices for Walk-Behind Snow Throwers Table of Contents Remove Snow Thrower from Carton Assembly / PRE-OPERATIONHOW to SET UP Your Snow Thrower Parts Packed Separately in CartonInstall Traction Drive Control ROD See Figs Install Speed Control ROD See FigsUnfold Upper Handle Install Discharge Chute / Chute Rotator Head See Fig Install Auger Control ROD See FigsCheck Tire Pressure Ignition KEY OperationKnow Your Snow Thrower PrimerElectric start button used for starting the engine Meets A.N.S.I. Safety RequirementsTo USE Choke Control See Fig HOW to USE Your Snow ThrowerStopping To USE Fuel SHUT-OFF Valve See FigTo Move Forward and Backward See Fig Using the CLEAN-OUT Tool See FigTo Adjust Skid Plates See Fig To Throw Snow See FigADD Gasoline See Fig Before Starting the EngineScraper BAR See Fig Check Engine OIL Level See FigBefore Stopping Snow Throwing TipsIf Recoil Starter has Frozen Maintenance Engine CleaningShear Bolts See Fig Service and AdjustmentsTo Adjust Snow Thrower Height Chute DeflectorTo Replace Belts See Fig Carburetor To Adjust Cable Tension See FigTo Adjust Traction Belt and Auger Belt Tension To Remove Wheels See FigEngine OIL StorageOther Fuel SystemTroubleshooting Exploded KEY Part Description Auger Assembly 30 RH Auger Assembly 30 LHCARRIAGEBOLT5/16−18X.625 Flange BLK 532 43 59-51 Plate Skid Plastic HdpePOP Rivet 532 18 45-11 Deflector WeldmentStrap Knob BlackRotator Pivot Bracket 532 42 82-72 LEVER/CABLE Rotator AssemblyCable Assembly Adjustable Cable Assembly Heat ShieldHandle Grip Repair Parts Snow Thrower Model P14530ES Handles532 44 36-17 Pivot Support Weldment Retainer Handle Knob 584 80 90-01 Interlock Control RODSpacer Knob REDInterlock Stop 01.10.001-BItem 42 Exploded Repair Parts Snow Thrower Model P14530ES DriveWheel HUB Speed Selector AssemblyShifter Link 532 40 26-89 Drive Plate Assembly 817 54 10-08 Thred Rolling ScrewRepair Parts KEY Part Description 532 43 07-64 Engine Mounting Plate 532 42 86-85 Cover Assembly580 42 61-01 LCT Complete Engine FrameWasher 5/16 Idler Pulley 585 20 02-01 Pulley ENG Impeller585 02 93-01 Pulley ENG Traction Belt GuideWheel Assembly LH Repair Parts Snow Thrower Model P14530ES WheelsWrench Repair Parts Snow Thrower Model P14530ES BAG of PartsPower Cord KEY Part Description 532 44 30-59 Safety Ignition KEY KITRepair Parts Snow Thrower Model P14530ES Decals Service Notes Service Notes Limited Warranty

P14530ES specifications

The Poulan P14530ES is a highly efficient chainsaw designed for homeowners and light-duty professionals who need a reliable tool for various cutting tasks. Featuring a powerful 14-amp motor, this electric chainsaw offers an impressive performance without the hassle of gas and oil. With its lightweight design, which weighs just under 10 pounds, the P14530ES ensures ease of handling and maneuverability, making it ideal for those who may not have extensive experience with chainsaws.

One of the standout features of the Poulan P14530ES is its easy starting system. Unlike traditional gas chainsaws that can be difficult to start, this electric model eliminates the need for pull cords. Users simply plug it in and press a button, allowing for immediate operation. This makes it particularly user-friendly, especially for novice users or those who might struggle with the pull-start mechanisms found in gas-powered saws.

The chainsaw also comes equipped with a 16-inch steel bar and chain, providing ample cutting capacity for tasks such as trimming, pruning, and cutting firewood. The chain itself is designed for low kickback, ensuring a safer cutting experience while still delivering precision and efficiency. The built-in automatic oiler keeps the chain well-lubricated during use, which minimizes wear and extends the tool's lifespan.

Durability is another key characteristic of the Poulan P14530ES. Constructed with high-quality materials, this chainsaw can withstand the rigors of regular use. It also features a transparent oil reservoir, allowing users to easily monitor oil levels and make sure the chain remains properly lubricated.

Safety features are paramount with the P14530ES, which includes a front hand guard and a chain brake to protect users from unexpected kickback. Additionally, the lightweight design reduces operator fatigue, enabling longer periods of use without discomfort.

In summary, the Poulan P14530ES is a solid choice for anyone looking for a dependable electric chainsaw. With its combination of power, ease of use, and safety features, it effectively meets the needs of homeowners and occasional users alike. Whether it's for yard maintenance or firewood preparation, this chainsaw stands out as a practical and efficient tool.
Top Page Image Contents