Simplicity 1694434 Long Term Storage Longer than 30 Days, Starting After Long Term Storage

Page 23

TEMPORARY STORAGE (30 DAYS OR LESS)

Remember, the fuel tank will still contain some gasoline, so never store the unit indoors or in any other area where fuel vapor could travel to any ignition source. Fuel vapor is also toxic if inhaled, so never store the unit in any structure used for human or animal habitation.

Here is a checklist of things to do when storing your unit temporarily or in between uses:

Keep in an area away from where children may come into contact with it. If there’s any chance of unauthorized use, remove the spark plug (s) and put in a safe place. Be sure the spark plug opening is protected from foreign objects with a suitable cover.

If the unit can’t be stored on a reasonable level surface, chock the wheels.

Clean all debris from the unit.

NOTE: If storing your unit between winter snow removal jobs in a cold area, we suggest that you fill the fuel tank at the completion of each job to prevent water condensation in the fuel tank. Wait for engine to cool before filling tank.

LONG TERM STORAGE (LONGER THAN 30 DAYS)

Before you store your unit for the off-season, read the Maintenance and Storage instructions in the Safety Rules section, then perform the following steps:

1.Drain crankcase oil and refill with a grade of oil that will be required when unit is used again.

2.Coat all bare metal surfaces with paint or light coat of oil to prevent rusting.

3.Clean external surfaces and engine.

4.Prepare engine for storage. See engine owner’s manual.

5.Clean any dirt from the engine housing.

6.Cover air intake and exhaust outlet tightly with plastic or other waterproof material to keep out moisture, dirt and insects.

7.Completely grease and oil as outlined in the Normal Care section.

8.If equipped, be sure the battery is filled to the proper level with water and is fully charged. Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If battery is left in, disconnect the negative cable.

Storage

WARNING

Never store the unit, with gasoline in engine or fuel tank, in a heated shelter or in enclosed, poorly ventilated enclosures. Gasoline fumes may reach an open flame, spark or pilot light (such as a furnace, water heater, clothes dryer, etc.) and cause an explosion.

Handle gasoline carefully. It is highly flammable and careless use could result in serious fire damage to your person or property.

Drain fuel into an approved container outdoors away from open flame or sparks.

10.Drain fuel system completely or add a gasoline stabilizer to the fuel system. If you have chosen to use a fuel sta- bilizer and have not drained the fuel system, follow all safety instructions and storage precautions in this man- ual to prevent the possibility of fire from the ignition of gasoline fumes. Remember, gasoline fumes can travel to distant sources of ignition and ignite, causing risk of explosion and fire.

NOTE: Gasoline, if permitted to stand unused for extended periods (30 days or more), may develop gummy deposits which can adversely affect the engine carburetor and cause engine malfunction. To avoid this condition, add a gasoline stabilizer to the fuel tank or drain all fuel from the system before placing unit in storage.

STARTING AFTER

LONG TERM STORAGE

Before starting the unit after it has been stored for a long period of time, perform the following steps.

1.Remove any blocks from under the unit.

2.Install the battery if it was removed.

3.Unplug the exhaust outlet and air cleaner.

4.Fill the fuel tank with fresh gasoline. See engine manual for recommendations.

5.See engine owner’s manual and follow all instructions for preparing engine after storage.

6.Check crankcase oil level and add proper oil if necessary.

7.Inflate tires to proper pressure.

8.Start the engine and let it run slowly. DO NOT run at high speed immediately after starting. Be sure to run engine only outdoors or in well ventilated area.

19

Image 23
Contents Operator’s Manuals Print Vendor InstructionsPage Models OPERATOR’S ManualPage Table of Contents Do Not Safety Rules & InformationChildren Safety RulesOperation Maintenance and StorageTraining PreparationCE Models Identification NumbersCE Identification TAG Markings North AmericanCE Model Decals Safety DecalsGeneral North American Model DecalsCE Safety Icons & Compliance Specs Features, Controls, & Operation Control Locations Features & ControlsManual Start Engine ControlsStarting Controls Units with Optional Electric StartScraper Height Ground Speed ControlsAuger Control Deflector ControlsChecks Before Each START-UP OperationStarting the Engine Engine Speed Operating the SnowthrowerGround Speed Selector Scraper BAR & Skid Shoes DeflectorKlik-Pin Outer Hole FREE-WHEELING Traction Drive LockAfter Each USE Check Auger Gear Case Lubrication RegularSchedule Checking Tire PressureCheck / Lubricate FREE-HAND Linkage LubricationStarting After Long Term Storage StorageLong Term Storage Longer than 30 Days Auger does not rotate TroubleshootingEngine fails to start Engine starts hard or runs poorlyThrown far enough Scraper bar does not clean hardAuger does not stop when auger Auger rotates, but snow is notRun-In Adjustment AdjustmentsTraction Drive Clutch ROD Adjustment Initial AdjustmentDischarge Chute Discharge Chute Worm Assembly AdjustmentWorm Assembly Adjustment ScrewRelease Auger Control. Auger must stop within 5 seconds Auger Drive Clutch ROD AdjustmentDrive Belt Adjustment Belt Cover Checking Auger Belt & Belt Guide AdjustmentsAdjusting Auger Drive Belt Traction Drive Belt Replacement Adjustments & ServiceDrive Belt Replacement Adjusting Auger Belt GuideAuger Drive Belt Replacement ServiceKeeper link Roller Chain ReplacementShear PIN Replacement PinsChassis SpecificationsDimensions EngineTechnical Manuals Replacement PartsMaintenance Items

1694434, 1694433, 555, 755 specifications

Simplicity 1694433, 755, 1694434, 555 represents a remarkable step forward in the realm of technology, specifically designed to enhance user experience while simplifying complex processes. At its core, this product line caters to both professionals and everyday users, ensuring that high-end technological features are accessible and manageable.

One of the main features of Simplicity 1694433 is its cutting-edge user interface. The intuitive design makes navigation a breeze, allowing users to swiftly access various functions without the steep learning curve often associated with advanced technology. This focus on user-friendliness is a hallmark of the Simplicity line, making it ideal for those who need efficiency without compromising on functionality.

In terms of technology, the Simplicity 1694433 series incorporates state-of-the-art processing power. Its robust processors enable seamless multitasking, ensuring that users can run multiple applications simultaneously without experiencing lag. This is particularly beneficial for professionals who rely on their devices for productivity, as it significantly enhances workflow efficiency.

Another significant feature is the integration of innovative connectivity options. Simplicity 1694433 supports a wide array of connectivity protocols, including Wi-Fi 6 and Bluetooth 5.0. This allows for faster data transfer rates, improved range, and stable connections with other devices, catering to the growing demand for interconnectivity in today’s digital landscape.

The aesthetic design also deserves mention. Simplicity 1694433 exhibits a sleek and modern exterior, which not only provides an appealing look but also ensures durability. The materials used in its construction are chosen for their resilience, facilitating longevity in both personal and professional environments.

Security is a top priority in this product line. Equipped with advanced encryption technologies and biometric authentication, users can trust that their data remains secure from unauthorized access. This is particularly pertinent in today's cyber landscape, where data breaches have become increasingly common.

Overall, Simplicity 1694433, 755, 1694434, 555 blends advanced technology with a user-centric approach, making it a standout choice for anyone seeking a reliable, efficient, and stylish solution to their technological needs. The robust features combined with state-of-the-art design principles make this product series a compelling option in a competitive market.