Snapper E9266, E11306 Annually END of Each Season, Engine Spark Plug, Storage Procedure

Page 14

Section 3 - MAINTENANCE

3.4 ANNUALLY (END OF EACH SEASON)

Perform all maintenance as described in the maintenance schedule.

3.4.1. Engine

Refer to engine owner’s manual for service instructions.

3.4.2. Spark Plug

Refer to engine owner’s manual for service instructions.

3.5 STORAGE PROCEDURE

Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the snow thrower for “end of season” storage as follows:

1.Drain fuel from fuel tank and let engine run until all fuel is out of the carburetor.

2.Disconnect and remove the spark plug wire away from spark plug before any other preparations are made!

3.Tape all openings closed to prevent spraying water into exhaust or air intakes during washing.

4.Tilt snow thrower up on its wheels and thoroughly clean the underside of the auger/impeller.

5.Lubricate all exposed metal with a light coating of oil to prevent corrosion.

6.Store the machine in a shed or other dry area, protected from weather.

3.6MAINTENANCE and SERVICE PARTS

MAINTENANCE and SERVICE PARTS

Auger Drive Belt (Briggs Engines)

1-3937

Auger Drive Belt (Tecumseh Engines)

1-3939

Wheel Drive Belt (Briggs Engines)

1-3936

Wheel Drive Belt (Tecumseh Engines)

2-9101

Scraper Blade (24” Width Auger)

3-6122

Scraper Blade (26” Width Auger)

3-9770

Scraper Blade (30” Width Auger)

3-6006

Rubber Drive Tire

1-0765

Shear Bolts - 5/16-18 x 1-7/8”

9-1550

Hex Nuts - 5/16-18

9-1298

Parts Manual for Large Frame Snow Throwers - Series 6

#06069

Models: 8245, 8265, E8265, 9265, E9265, E9266, 10305,

 

E10305, 10305E, E10305E, E11305, E11306, N10305E

 

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Instruction No -4243 I.R /15/01 Model Number ExplanationModel Designation Series Designation Engine HP Auger Width Preparation Operational PrecautionsProtection for Children Maintenance and Storage Table of Contents Rabbit / Fast Turtle / Slow Neutral European Community Hearing Protection RequiredForward Reverse Ground Speed Control Year of Manufacture Safety Instructions to Prevent Injury Sound Power LevelIntroduction NomenclatureMinimum Gauge for Cord Sets PRE-START Check ListSTARTING, Operation & Stopping Recoil Start Models Go to Page 11 for Electric Start Models EngineEngaging Wheel Drive Discharge Chute and Deflector AdjustmentEngaging Auger STARTING, Operation & Stopping Electric Start Models Stopping ENGINE, Auger & Wheel Drive Free Wheel MachineGear CASE, Auger Shaft and Auger Bearing Lubrication Service After First 5 Hours Check Auger Drive BeltGeneral Lubrication Check Wheel Drive BeltAnnually END of Each Season Storage ProcedureMaintenance and Service Parts Engine Spark PlugAuger and Drive Belt Adjustment Cable Adjustment Auger Belt Adjustment Idler Pulley AdjustmentRecheck cable for proper extension Reinstall belt cover Repair & Adjustments Skid Shoe Adjustment Single Handle Control Adjustment Chute Crank Adjustment Rubber Drive Tire Replacement100 Problem Probable Cause Corrective ActionService Performed Each USE HRS SeasonYear Limited Warranty Disclaimer of WarrantyPage European TWO Stage Large Frame Snow Thrower Series
Top Page Image Contents