Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform all maintenance as described in the maintenance schedule.
3.4.1. Engine
Refer to engine owner’s manual for service instructions.
3.4.2. Spark Plug
Refer to engine owner’s manual for service instructions.
3.5 STORAGE PROCEDURE
Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the snow thrower for “end of season” storage as follows:
1.Drain fuel from fuel tank and let engine run until all fuel is out of the carburetor.
2.Disconnect and remove the spark plug wire away from spark plug before any other preparations are made!
3.Tape all openings closed to prevent spraying water into exhaust or air intakes during washing.
4.Tilt snow thrower up on its wheels and thoroughly clean the underside of the auger/impeller.
5.Lubricate all exposed metal with a light coating of oil to prevent corrosion.
6.Store the machine in a shed or other dry area, protected from weather.
3.6MAINTENANCE and SERVICE PARTS
MAINTENANCE and SERVICE PARTS
Auger Drive Belt (Briggs Engines) | |
Auger Drive Belt (Tecumseh Engines) | |
Wheel Drive Belt (Briggs Engines) | |
Wheel Drive Belt (Tecumseh Engines) | |
Scraper Blade (24” Width Auger) | |
Scraper Blade (26” Width Auger) | |
Scraper Blade (30” Width Auger) | |
Rubber Drive Tire | |
Shear Bolts - | |
Hex Nuts - | |
Parts Manual for Large Frame Snow Throwers - Series 6 | #06069 |
Models: 8246, 9266, 9266E, 11306 |
|
12