Section 2 - OPERATING INSTRUCTIONS
2.1PRE-START CHECK LIST
2.1.9.Check the AC electrical outlet that will be used and make sure it is a polarized outlet. The machine has a polarized plug (one blade of plug is wider than the other) that will accept a polarized extension cord. The extension cord will fit into a polarized outlet (receptacle) only one way. If plug does not fit fully into your outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper polarized outlet. DO NOT modify or change this polarized plug in any way.
2.2STARTING, OPERATION & STOPPING (RECOIL START MODELS)
2.2.1.ENGINE
1.Turn fuel shut off valve to the “ON” position. See Figure 2.3.
TURN VALVE TO “ON” POSITION
FIGURE 2.3
2.Insert key into ignition switch. See Figure 2.4.
3.Move choke control to the choke, “ON” position. See Figure 2.4.
4.Move engine speed control to the “FAST” position. See Figure 2.4.
5.Push primer button three times to start a cold engine. NOTE: Do not use primer button to start warm engine. See Figure 2.4.
IMPORTANT: Stop the auger/impeller and wheel drive by releasing the auger/impeller and wheel drive control levers. Stop the engine by moving the engine speed control to stop or removing the key from the switch.
MOVE CHOKE TO THE “ON” POSITION
PUSH PRIMER
THREE TIMES
MOVE ENGINE
SPEED CONTROL
TO FAST
INSERT
KEY
FIGURE 2.4
6.Pull rope start handle to crank engine.
7.After engine starts, move the choke control to the no choke, “OFF” position. Allow a brief
(Continued on Next Page)
7