Snapper 8246, 9266E, 9266, 11306, 8246, 9266, 9266E, E9266, 11306, E11306 Table of Contents

Page 4

TABLE OF CONTENTS
SECTION 1 - IMPORTANT SAFETY INSTRUCTIONS	2-3
TABLE OF CONTENTS	4
SECTION 2 - OPERATING INSTRUCTIONS	5-10
Introduction	5
Pre-start Checklist	6-7
Starting & Stopping Engine (Recoil Start Models)	7-10
Starting & Stopping Engine (Electric Start Models)	9-10
Starting & Stopping Auger/Impeller	8-10
Starting & Stopping Wheel Drive	8-10
Free Wheel Machine	10
SECTION 3 - MAINTENANCE INSTRUCTIONS	11-12
Checking Auger Drive Belt	11
Checking Wheel Drive Belt	11
Lubricate Gear Case	11
Lubricate Auger & Bearing	11
General Lubrication	11
Annually (End of Season)	12
Changing Engine Oil	12
Changing Spark Plug	12
Storage Procedure	12
Maintenance and Service Parts	12
SECTION 4 - ADJUSTMENTS AND REPAIR	13-18
Auger/Impeller & Wheel Drive Belt Adjustment	13-14
Auger/Impeller & Wheel Drive Belt Replacement	14-15
Skid Shoe Adjustment	16
Single Handle Control Adjustment	17
Auger Shear Bolt Replacement	18
Chute Crank Adjustment	18
Rubber Drive Tire Replacement	18
TROUBLESHOOTING	19
SERVICE SCHEDULE	19
WARRANTY AND PRODUCT REGISTRATION	20-21

IMPORTANT

The figures and illustrations in this manual are provided for reference only and may differ from your specific model. Contact your Snapper dealer if you have questions.

4

Image 4

Contents Engine HP Electric Start Auger Width Series Designation Model Number ExplanationManual No -5394 I.R /3/03 Protection for Children Operational PrecautionsPreparation Safe Handling of Gasoline Maintenance and StorageDo not refuel the machine indoors Table of Contents Introduction NomenclatureMinimum Gauge for Cord Sets PRE-START Check ListSTARTING, Operation & Stopping Recoil Start Models EngineEngaging Auger Discharge Chute and Deflector AdjustmentEngaging Wheel Drive STARTING, Operation & Stopping Electric Start Models Stopping ENGINE, Auger & Wheel Drive Free Wheel MachineService After First 5 Hours Check Auger Drive Belt General LubricationGear CASE, Auger Shaft and Auger Bearing Lubrication Check Wheel Drive BeltStorage Procedure Maintenance and Service PartsAnnually END of Each Season Engine Spark PlugAuger and Wheel Drive Cable Adjustment Auger Belt Idler Pulley AdjustmentRecheck cable for proper extension 3/8 Reinstall belt cover Repair & Adjustments Skid Shoe Adjustment Single Handle Control Adjustment Chute Crank Adjustment Rubber Drive Tire ReplacementProblem Probable Cause Corrective Action Service Performed Each100 USE HRS SeasonYear Limited Warranty Disclaimer of WarrantySnapper Product Registration Form Page Page Page TWO Stage Large Frame Snow Thrower Series Instruction No -5394 I.R /3/03