Snapper LE3171R, LE3191R, LE3191E Protection for Children, Preparation, Operational Precautions

Page 2

IMPORTANT SAFETY INSTRUCTIONS

WARNING: This powerful machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following instructions may result in serious injury to the operator or other persons. The owner of the snow thrower must understand these instructions and, furthermore, must allow only persons who understand these instructions to operate snow thrower. Each person operating the snow thrower must be of sound mind and body and must not be under the influence of any substance, which might impair vision, dexterity, or judgment. If you have any questions pertaining to your snow thrower which your dealer cannot answer to your satisfaction, call or write the Customer Service Department at SNAPPER, McDonough, Georgia 30253. Phone: 800/935-2967.

PROTECTION FOR CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the snow removal activity. Never assume that the children will remain where you last saw them.

1.DO NOT allow children in the area when snow thrower is being operated.

2.DO NOT allow pre-teenage children to operate snow thrower.

3.ALLOW only responsible adults and teenagers with mature judgment to operate the machine and then only after being thoroughly instructed and under the close supervision of an experienced adult operator.

4.Keep the area clear of all persons, particularly small children and pets.

5.Know how to STOP the snow thrower and disengage the controls quickly.

PREPARATION

8.Survey the area to be cleared beforehand and plan where snow is to be blown. Be prepared to release auger/impeller clutch or to change discharge chute direction quickly to discharge away from windows, cars, buildings and doorways to avoid property damage or personal injury from hurled objects.

9.Use only approved extension cords and receptacles in good condition and with sufficient capacity to carry the current to the machine if equipped with electric starting motors.

10.Handle fuel with extra care. Fuels are flammable and vapors are explosive. Store only in an approved fuel container. Never remove fuel cap or add fuel with the engine running. Add fuel outdoors only with the engine stopped and cool. Clean spilled fuel and oil from machine. DO NOT smoke. DO NOT run engine indoors.

PREPARATION

1.Warn everyone in advance to stay clear of area. Keep especially watchful for children and pets darting into area while operating.

2.Read, understand, and follow instructions and warnings in this manual and on the machine. Know the controls and the proper use of the snow thrower before starting.

3.Data indicates that operators, age 60 and above, are involved in a large percentage of snow thrower-related injuries. These operators should evaluate their ability to operate the snow thrower safely enough to protect themselves and others from serious injury.

4.Disengage all clutches and shift into neutral before starting the engine (motor).

5.Wear adequate winter clothing including boots which will give you maximum footing on slippery surfaces. Exercise CAUTION to avoid slipping or falling.

6.DO NOT wear loose fitting clothing that can get caught in moving parts.

7.Before the first snow fall, check the area to be cleared and remove all objects such as doormats, sticks, toys, wires, rocks, etc., which could be hurled or jam the snow thrower.

OPERATIONAL PRECAUTIONS

1.Before starting, make visual check to make sure auger/impeller housing is clear and all guards and shields are in place and tight.

2.DO NOT operate machine without proper guards shields, deflectors, or other safety protective devices in place and functioning properly.

3.Should the auger/impeller become clogged, release the auger/impeller clutch control and, as an additional precaution, STOP the engine before attempting to unclog the auger/impeller or discharge chute.

4.DO NOT attempt to unclog the auger/impeller or discharge chute by reaching in with your hands. Use the clean-out tool or similar implement to unclog.

5.DO NOT attempt to unclog the auger/impeller or discharge chute with the engine running. STOP engine and remove key. Wait for all motion to STOP.

6.STOP engine (motor) and remove key before leaving the operator position for any reason.

DO NOT put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Single Stage Small Frame Snow Thrower Series Model Number ExplanationPreparation Operational PrecautionsProtection for Children Clearing a Clogged Discharge Chute Safe Handling of GasolineMaintenance and Storage Table of Contents PRE-START Check List Gasoline Cycle OILMinimum Gauge for Cord Sets Engaging Auger Stopping Operating Instructions Introduction Service After First 5 Hours Check Auger Drive BeltStorage Procedure Check Auger Flite ShoeAuger Belt Cable Adjustment Auger Belt Idler Pulley AdjustmentAuger Belt Replacement From PreviousRepair & Adjustments MAINTENANCE/REPLACEMENT Parts Problem Probable CauseService Performed Each Corrective ActionYear Limited Warranty Disclaimer of WarrantySnapper Product Registration Form Single Stage Small Frame Snow Thrower Series

LE3171R, LE3191R, LE3191E specifications

The Snapper LE3171R, LE3191R, and LE3191E are part of Snapper’s innovative line of lawn mowers, designed to meet the diverse needs of lawn enthusiasts and professionals alike. Each model presents a unique blend of features, advanced technologies, and robust characteristics, ensuring efficient and effective lawn care.

The Snapper LE3171R is powered by a reliable engine that provides ample torque and performance for tackling various grass types. Its cutting deck is designed for a precise and clean cut, ensuring a professional finish for residential and commercial lawns. The model boasts a compact size, making it nimble enough to navigate tight spaces and flower beds with ease. Featuring a user-friendly design, assembling and starting the LE3171R is straightforward, appealing to both seasoned operators and those new to lawn maintenance.

Moving to the LE3191R, this model takes performance to another level with a more powerful engine, allowing for faster mowing speeds and enhanced durability. The LE3191R is equipped with a larger cutting deck, which underlines its capacity for handling larger areas efficiently. It incorporates advanced mulching technology, which finely chops grass clippings, returning nutrients to the soil and reducing the need for fertilizer. This model is designed with operator comfort in mind, offering adjustable handle heights to suit various user preferences, ensuring a comfortable mowing experience.

The Snapper LE3191E variant emphasizes eco-friendliness and efficiency with its innovative electric motor. Perfect for those who prioritize sustainability, the LE3191E operates quietly without the emissions typical of gas engines. This model features a robust battery system that provides ample runtime for cutting medium to large lawns without interruption. Additionally, it includes smart technology, allowing users to monitor battery levels and even schedule mowing sessions through a dedicated app, enhancing convenience and user control.

All three models are characterized by their sturdy construction and reliable performance, showcasing Snapper’s commitment to quality. Each mower incorporates safety features such as blade brake systems and ergonomic controls, ensuring user safety during operation. The LE3171R, LE3191R, and LE3191E reflect Snapper’s dedication to creating versatile, efficient, and user-centric mowing solutions tailored for today's diverse lawn care needs. These models are indeed ideal choices for any homeowner or professional landscaper looking to achieve the perfect lawn.
Top Page Image Contents